Upload
adam-englander
View
129
Download
0
Embed Size (px)
Citation preview
+Historical PerspectiveHow I came up with the hair-brained idea that everyone could do IoT development
+
Physical Access SystemComprised of Raspberry Pi B, power converter, electronic door latch, inline switch. Software is Raspbian with Python 2.7 and Twisted.
+Starter Kit Hardware
Raspberry Pi Micro USB with AC converter for power Cat 5 network cable USB Keyboard HDMI cable HDMI capable display – not shown 3.3V LED with (2) female to female
connectors
+Starter Kit Software
Raspbian Pre-installed on SD card Download installer (requires SD card
reader): https://www.raspberrypi.org/downloads/
+General Purpose Input/Output (GPIO)
A generic pin on an integrated circuit (IC) whose behavior is controlled at runtime
Use to control and transfer data to and from external devices to the IC
Available on all general purpose IC boards
+ It’s All In The File System
Linux GPIO Sysfs Interface for Userspace
Root directory is at /sys/class/gpio Control Interfaces Pin Interfaces
+Control Interface
“export” creates a node to expose a GPIO port to the user space “echo 18 > /sys/class/gpio/export”
will create a gpio18 node at “/sys/class/gpio/gpio18”
“unexport” removes the node for a GPIO port from the user space “echo 18 >
/sys/class/gpio/unexport” removes the gpio18 node
+GPIO Signals
“direction” determines the direction of a pin. Valid values are “in” and “out”. “in” is used for interrupts “echo out > /sys/class/gpio/gpio18/direction”
will set GPIO pin 18 ’s direction as out “value” is the value of a pin. It reads a “0” or
“1”. Any on-zero value written will be interpreted as “1”. When reading the value ”high” evaluates to ”1” and “low” evaluates to “0” unless overridden by “active_low” “echo 1 > /sys/class/gpio/gpio18/value” sets
the value of GPIO 18 to “1” and closes the circuit
“cat /sys/class/gpio/gpio18/value” would return “1” after the statement above
+GPIO Signals Continued
“edge” is used to tell the GPIO when to write to ”value” when “direction” is “in”. Valid values are “none”, “rising”, ”falling”, and “both”. “echo both >
sys/class/gpio/gpio18/edge” will trigger an interrupt when voltage increases or decreases
“active_low” is used to invert the effect of “edge” of “value”. Valid values are “1`” and “0”. “1” inverts and “0” sets standard. “echo 1>
sys/class/gpio/gpio18/active_low” will invert the values of high and low
+Further Reading
Raspberry Pi: https://www.raspberrypi.org/
Intel Edison: http://www.intel.com/content/www/us/en/do-it-yourself/edison.html
CHIP: https://getchip.com/pages/chip Tessel: https://tessel.io/ Linux Kernel GPIO Sysfs: https://
www.kernel.org/doc/Documentation/gpio/sysfs.txt
+Contact Info
@adam_englander on Twitter [email protected] aenglander on Freenode aenglander on GitHub adamenglander on Linkedn