© Derechos reservados AVL, JADD, AJBG, queda prohibida ...±o...Assuming that σA ≥ σ B, there...

UDA 3. Teorías de Falla Diseñó Estático

FAILURE THEORIES

(From Shigley’s Mechanical Engineering

Design)

MSS theory is an acceptable but conservative predictor of failure; and since engineers are conservative by nature, it is quite often used.

For a general state of stress, three principal stresses can be determined and ordered such that σ1 ≥ σ2 ≥ σ3.

Assuming that σA ≥ σB, there are three cases to consider for plane stress:

Case 1: σA ≥ σB ≥ 0. For this case, σ1 = σA and σ3 = 0. Equation reduces to a yield condition of

Case 2: σA ≥ 0 ≥ σB . Here, σ1 = σA and σ3 = σB , and Eq. becomes

Case 3: 0 ≥ σA ≥ σB . For this case, σ1 = 0 and σ3 = σB , and Eq. gives

The distortion-energy (DE) theory originated from the observation that ductile materials stressed hydrostatically exhibited yield strengths greatly in excess of the values given by the simple tension test.

For the element showed the strain energy per unit volume is

The strain energy for producing only volume change

Then the distortion energy is obtained by subtracting from u

For the simple tensile test, at yield, σ1 = Sy and σ2 = σ3 = 0, so the distortion energy is

So for the general state of stress given, yield is predicted if equals or exceeds This gives

Before we saw that…

A single, equivalent, or effective stress for the entire general state of stress given by σ1, σ2, and σ3 is usually called the von Mises stress, σ′, named after Dr. R. von Mises, who contributed to the theory.

For plane stress, let σA and σB be the two nonzero principal stresses then the von Mises stress is given by:

The equations given allow the most complicated stress situation to be represented by a single quantity, the von Mises stress, which then can be compared against the yield strength of the material through

The distortion-energy theory predicts no failure under hydrostatic stress and agrees well with all data for ductile behavior. Hence, it is the most widely used theory for ductile materials and is recommended for design problems unless otherwise specified.

The shear yield strength predicted by the distortion-energy theory is which as stated earlier, is about 15 percent greater than the 0.5 Sy predicted by the MSS theory.

Not all materials have compressive strengths equal to their corresponding tensile values.

For example, the yield strength of magnesium alloys in compression may be as little as 50 percent of their yield strength in tension. Coulomb-Mohr theory or the internal-friction theory

For design equations, incorporating the factor of safety n, divide all strengths by n.

Shah (2009)

FAILURE THEORIES

(From Shigley’s Mechanical Engineering

Design)

The maximum-normal-stress (MNS) theory states that failure occurs whenever one of the three principal stresses equals or exceeds the strength. The principal stresses for a general stress state in the ordered form σ1 ≥ σ2 ≥ σ3. This theory then predicts that failure occurs whenever

where Sut and Suc are the ultimate tensile and compressive strengths, respectively, given as positive quantities.

For plane stress, with σA ≥ σB,

σA ≥ Sut or σB ≤ −Suc

Graph of maximum-normal stress (MNS) theory of failure for plane stress states. Stress states that plot inside the failure locus are safe.

Esfuerzos principales

© Derechos reservados AVL, JADD, AJBG, queda prohibida ...±o...Assuming that σA ≥ σ B, there...

Documents

Jadd ul mumtar ala radd ul mohtar by ala hazrat vol 5

VRT) · 3ο Σ νέδριο Γεωγραφικών Πληροφοριακών Σ σ ημάων και Χωρικής Ανάλ σης σ η Γεωργία και σ ο

NAU8820 Low Power 24-bit Stereo Audio Codec with High Current Outputs … · 2016. 8. 18. · hpf alc notch filter limiter 5 band eq 3d Σ Σ Σ Σ alc control Σ Σ rinmix ldac rdac

WCCI 2016-2018. Results in section C - Moremovers. · 4Mihalco, Oto SK 2.117 5Efrosinin, Oleg RU 1.784 Ranking: №1 №2 №3 №4 №5 №6 Σ Σ Σ Σ Σ Σ AF 1 Marandyuk,

Jadd ul mumtar ala radd ul mohtar by ala hazrat vol 4

Computation of reinforcement for solid concreteheronjournal.nl/53-4/3.pdf · 2012. 2. 18. · 251 Figure 3. Surface areas of the cracked cube part σ=σ −cx xx x yρ σ σ=σ −cy

Σ Rέλεχος Σ Rενογρά Tος - Σεμινάρια · RhinoGold ArhiCAD Sketch

Rogers Infant Start Outcome Paper JADD 2014

Le3b w Jadd Summer Camp

AnalysisofCarbonNanotubeson ...downloads.hindawi.com/journals/jnm/2011/805313.pdfJournal of Nanomaterials 3 σa σa (a) B D A C Ma0 Ma0 θa Pa Pa (b) Figure 2: Force analysis of armchair

Smr 1555 n 3indico.ictp.it/event/a0335/session/102/contribution/62/...1 k∞----- υΣ f 1 φ 1 υΣ f 2 φ 2 ()Σ+ a 1 φ 1 Σ 12 φ 1 = + Σ12φ1 Σa 2 = φ2 HOMOGENEOUS CALCULATIONS

Braid-based cryptography - Patrick Dehornoy · BRAID-BASED CRYPTOGRAPHY 3 = = = = σ−1 i σ i+1 σ i σ i 1 σ i i σ i σ i σ i σ−1 σ i+1 +1 i+2 i+2 Figure 2. Geometric interpretation

Δ Ε Σ Μ Ο Σ Γ Ι Α Τ Ο Υ Σ Ν Ε Ο Υ Σ - newsbomb.gr...2017/04/12 · " Δ Ε Σ Μ Ο Σ Γ Ι Α Τ Ο Υ Σ Ν Ε Ο Υ Σ " Π Ο Ι Ο Τ Ι Κ Ο Σ Α Ν Τ

Σ πανιε Σ γ αιε Σ - PublicΣ πανιε Σ γ αιε Σ 15 τραγικό τρόπο– κι ένα κεφάλαιο μετά την Ντάρια Πλα-τόνοβα που

Introduction to the t Statistic. What were the formulae used for the z statistic? z = (M – μ) / σ m z = (M – μ) / σ m σ m = σ/n σ m = σ/n σ = (SS/n) σ

Το Γράμμα Σ, σ

ΤΑΞΗ: Α΄ ΜΑΘΗΜΑ: ΘΡΗΣΚΕΥΤΙΚΑ ΔΙΔΑΣΚΩΝ: …Σ.141, ΚΟΜΙΚΣ Σ.146-147 Σ.149-150, ΒΙΟΜΗΧΑΝΙΚΟ ΣΧΕ∆ΙΟ, DESIGN Σ.160-161, COCA COLA,

トポロジカル絶縁体・超伝導体qft.web/2009/slides/...2 σ ∈Ζ× Edge states GS σ xy =−2 σ xy =−1 σ xy =0 σ xy =+1 σ xy =+2 Quantum phase transitions Space of

ΤΟ ΓΡΑΜΜΑ Σ,σ, ς

Σ xριάνι σ ο χρόνο, σ ένα αξίι ισ ορίας ......Παιδείας, Ελλάδας και Κύπρο (ο πρώος σ όχος ης χρονιάς «Γνωρίζω,