2006-07 Jeep Commander - scosche.com · Images Front Speaker Radio removal Front Speaker(s) Rear...

+12v Constant = Red/Orange +12v Acc. Switch = None (CAN BUS) -12v Chassis Ground= None (CAN BUS) +12v Illumination = None +12v Dimmer = NoneAntenna/Amp Remote =None (CAN BUS)

LF+ = NoneLF- = None

RF+ = None RF- = None LR+ = Green/Blue LR- = Green/Purple RR+ = Grey/Blue RR- = Grey/Blue

Dash Type : Din and 1/2Aftermarket: Single/Double DinKit: CR1286B/CR1289BHarness: CR03SRAntenna Adapter: CRAB/CRARB

About the Vehicle

Make: JeepModel: CommanderYear: 2006-07

In Dash Application

Wire Color Codes

Speaker Notes

Front Speaker Sizes

Rear

NOTES

Dimensions: Lower Door

Dimensions: Lower Door W= 7.180'' L= 2.841'' D= 5.835''

NOTES

Rear Door: 6.5'' MidrangeSpeaker Adapter: SAC656Factory Assembly: (3) Phillips head screws securingspeaker.

Standard/Optional

Ampli�er Locations: Behind Left Rear Side Panel.

W= 6.169'' L= 8.778'' D= 3.143''

Type: Standard Audio System Location: At Speakers

Speaker Sizes

Front Dash: 3.5'' TweeterLower Door: 6X9 MidrangeSpeaker Adapter: SA69Speaker harness: TBAFactory Assembly: (4) Phillips Head screws securingspeaker.

CD PlayerBoston Acoustic Sound SystemIn-Dash CD Changer (6 Disc)Satellite RadioNavigation SystemRear Seat DVD System6 Speaker System

Jeep Commander2006-07

Images

Front Speaker

Radio removal

Front Speaker(s)

Rear Speaker(s)Rear Speaker

Radio

Tweeter

1. Remove (16) silver Allen head screws from front of dash.Carefully pull dash from right front corner to releaseretainer clips.Then continue releasing retainer clips alongtop of dash from right to left.There are two clips on dash above steering column that need to be released.There is (1)clip on dash right below radio. Once all clips releasedremove dash.2. Remove (2) Philips screws on each side of radio and pull out.

Dash Tweeter

Front Door

1. Remove screw under door closer handle. 2. Remove plastic screw cover behind door opener handle. Remove screw. Unsnap door panel. Lift panel up and pull out.3. Disconnect plugs from door panel. Disconnect door opener rod. Remove (3) screws holding speaker in.

1. Use small panel remover and pop grill off.There are (4) clips holding grill on.2. Remove (2) screws from speaker and remove

1. Remove screw from upper door panel closest to vehicle.2. Remove screw under door closer handle. Remove plasticscrew cover behind door opener handle. Remove screw.Unsnap door panel. Lift panel up and pull out.3. Disconnect plugs from door panel. Disconnect door openerrod.4. Remove (4) screws holding speaker in.

Rear Door

Jeep Commander2006-07