Absorber Design Concept

1

Absorber Design Concept

RIKEN/RBRCItaru Nakagawa

2　

2.34 meters

f 56cm２ 1cm

35 cm

37°

10°

16cm

A (thickness 16cm) B (thickness 19cm)

Volume 0.38 m3 0.58 m3

Net Weight 3.4t 5.2t

19cm

２ 7cm

Material : Copper, Brass, Bronze, Stainless SteelTotal 8.6t

3

１ ２

３４

Since Flower pot is tapered, we cannot install absorber fromthe back if absorber is made in one body. Ring design also faces same installation problem.

Thus the present idea is to segment front and back absorbers into 4 pieces,respectively. Total 8 pieces.

4

１ ２

３４

If the company make the absorber by casting of whole absorber and then chop into pieces,then there will be space in the order of a few mm. If they do machining each pieces, then thejoints will be exact (less than mm).

We’ll fill out this gap with spacers, if we found it is necessary.

5

Constraint of Installation

absorber

Counter weight

Crane Max = 12t

Each absorber piece Is preferably less than2 tons. (Don) 8 pieces segmentationbrings each piece about 1t.

6

~ 25cm

Interference w/ BBC Cables

BBC cables are running at 25 cm elevationfrom the surface of central magnet back.We need to re-route cables at the elevationof 35cm on top of the absorber back surface.

Andrew Cables

Andrew cable/connectors are very stiff. Minimum bending angle and number of timesare strictly limited.

7

8

Modification of BBC Patch Connection

9

Flower Pot Design (South)

10cm

New patch panel

(66mm)

10

Available Space

90mm

11

Japanese CompaniesCompany Material Manufacture Quote Comment

Izumi Metal / Akaboshi co. ltd. Bronze Casting Next week Confident in time

Sumitomo Heavy Industrial ltd.

Brass Casting $300k Difficulty in time

Copper Plate Faster, but 4 layers

Hitachi Engineering

Oxygen Free Copper Forging 3/18

Yuasa Ltd. Brass Casting Next week

Tohoku Oye Industry Next week

Takano Giken Brass Next week

Okamoto Brass Casting $220k + machining

12

Stainless Steel

Company Material Machining Quote Comment

Giken-Seiki Co. SUS310? Lathe TurningExperienced w/

SUS316 B<40uT

Iijima Machinary Co. Appointment 3/19

Yagita Giken Co. SUS310? ASAP

Inoue Material Need Drawing to Estimate

13

Permeability of SUS