View
213
Download
0
Category
Preview:
Citation preview
Anderson Power Pole Connectors (APPC)30 Amp
Standard configuration: RED on the Right, BLACK on the LeftConnection points on the bottom half Presentation Prepared By:
Bob Haynie KC7JOK
02-Jan-08
Housings And
Wire End Connectors
With the Connection Tabs Down
LeftRight
The wire end connectors are soldered or crimpedon the wires then insertedinto the housing until it snaps and locks into place.
Slide the 2 housings together The housings will stay together
If you don’t Solder you can use special crimpers to assemble your connectors
Be very careful how you use the crimpers
If you crimp the wire end connectors on the wrong sideit will flare the connector and make it very difficult andalmost impossible to insert in the plastic housing.
The wire end connectors are split on one side
Place the split side of the wireend connector against this sideof the crimpers.
Correct
Wrong
Ready to Crimp
Correctly Crimped
Notice the connector splitside is not deformed and is nice, round and smooth
Completed and un-assembled components
I use heat shrink over the wires to hold them together and also keep the housings for sliding apart.A small roll pin can also be inserted in the center to keep the housings from sliding apart.
Recommended