View
3
Download
0
Category
Preview:
Citation preview
VICTORIAPhone: (61 3) 9587 7700Facsimile: (61 3) 9587 7711
NEW SOUTH WALESPhone: (61 2) 9791 1011Facsimile: (61 2) 9791 1022
QUEENSLANDPhone: (61 7) 3272 7500Facsimile: (61 7) 3272 7505
SOUTH AUSTRALIAPhone: (61 8) 8297 1722Facsimile: (61 8) 8297 1733
www.hales.com.au
Toll Free: 1300 660 854
Sintered Vents
Used for Blow Moulding, Diecastingor Vacuum CastingPore Diameter: 0.30mm
Product Code 30510 30610 30615 30810 30815 31010 31015 31210 31215 31415
Diameter 5 6 6 8 8 10 10 12 12 14
No. of Pores 89 89 89 200 200 340 340 340 340 550
Length 10 10 15 10 15 10 15 10 15 15
Used for Plastic Injection MouldingPore Diameter: 0.03 ~ 0.10mm
Product Code SV030410 SV030610 SV030810 SV031010 SV050610 SV050810 SV051010 SV100810 SV101010
Outer Diameter 4 6 8 10 6 8 10 8 10
Eff. Diameter 2.5 2.5 2.5 2.5 3.5 3.5 3.5 5.5 5.5
No. of Pores 880 880 880 880 880 880 880 880 880
Length 10 10 10 10 10 10 10 10 10
Length
Diameter
Length
Diameter EffectiveDiameter
The pores allow trapped air or gas to escape from the mould cavity during the injection moulding or die casting process, thereby reducing the occurrence of defective parts.
Pore diameter
Pore diameter
SINTERED VENTSAssists with purging air and gasduring the moulding process.
Insulation Sheet• Machined to suit your application.
• Polyester glass laminate.
• Low thermal conductivity continuous to 220C. Standard sheet also available.
• 0.8-50mm thick available.
Also Available at Hales
Countersink holes
Location ring cut out
Cap screw clearance hole
Contact Hales on info@hales.com.au or call 1300 660 854 for more information
Recommended