BL fiberSOURCE LV3 Series · How-To Use LV3 Series Interface (located on the back of light...

For more information, please download the BL LIGHTING catalogue

BL LIGHTING. ILLUMINATE EVERYTHING111 - 8838 Heather St. Vancouver, BC. Canada. V6P 3S8 P: 1-604-874-4405 F: 1-604-321-0445 E: info@bllighting.com Copyright © 2017 BL INNOVATIVE LIGHTING. All Rights Reserved.

PROJECT CLIENT TYPE

Solid State Lighting is sensitive to power fluctuationsSurge protection is highly recommended for all LED lighting products and should be on a designated circuit to protect against premature failureLack of surge protection may void your warranty

bllighting.com

INSTALLATION - D01 -

Printed

Local building and electrical codes should beconsulted before installation.

Please note that these instructions are guidelines only and in no way supersede any construction or installation standards.

ATTENTION• There is potential danger of electrical shock when operating electrical components.• Make sure power is turned off before installation.• Allow for heat dissipation and adequate ventilation.

2

1

SET-UPHow To Position + Configure

How-To Use LV3 Series Interface (located on the back of light source):

MODE - Switches through LV3 Series pre-setsLIGHTMIX - A USB port that plugs direct into your PCDMX - A Cat5 Cable that syncs your DMX signal12VDC - Direct plug-in barrel connector.

1.

A. Insert BL fiberOPTIC into fiber port and tighten.B. Slide fiber port into shaft on the LV3 Series and fasten screw.

LED Light Engine Designed for BL fiberOPTIC36W, Mono or Polychromatic, DMX512

BL fiberSOURCE LV3 Series

Daisy-ChainMax. 50FT

Single LoopMax. 50FT

Dead-EndedMax. 25FT

Diameter

5/32”1/4”3/8”1/2”

Max. No. of Strands per Fiber Port

24622

Fiber + Light Source Capacity

BL fiberOPTIC SL SERIESOptional Layouts with LV3 Series

For more information, please download the BL LIGHTING catalogue

BL LIGHTING. ILLUMINATE EVERYTHING111 - 8838 Heather St. Vancouver, BC. Canada. V6P 3S8 P: 1-604-874-4405 F: 1-604-321-0445 E: info@bllighting.com Copyright © 2017 BL INNOVATIVE LIGHTING. All Rights Reserved.

PROJECT CLIENT TYPE

Solid State Lighting is sensitive to power fluctuationsSurge protection is highly recommended for all LED lighting products and should be on a designated circuit to protect against premature failureLack of surge protection may void your warranty

bllighting.com

INSTALLATION - D02 -

Printed

Local building and electrical codes should beconsulted before installation.

Please note that these instructions are guidelines only and in no way supersede any construction or installation standards.

ATTENTION• There is potential danger of electrical shock when operating electrical components.• Make sure power is turned off before installation.• Allow for heat dissipation and adequate ventilation.

LED Light Engine Designed for BL fiberOPTIC36W, Mono or Polychromatic, DMX512

BL fiberSOURCE LV3 Series

BL fiberOPTIC EL SERIESEnd Light Arrangement with LV3 Series

NOTE: End Light Fixture Optional

For more information, please download the BL LIGHTING catalogue

BL LIGHTING. ILLUMINATE EVERYTHING111 - 8838 Heather St. Vancouver, BC. Canada. V6P 3S8 P: 1-604-874-4405 F: 1-604-321-0445 E: info@bllighting.com Copyright © 2017 BL INNOVATIVE LIGHTING. All Rights Reserved.

PROJECT CLIENT TYPE

Solid State Lighting is sensitive to power fluctuationsSurge protection is highly recommended for all LED lighting products and should be on a designated circuit to protect against premature failureLack of surge protection may void your warranty

bllighting.com

INSTALLATION - D03 -

Printed

Local building and electrical codes should beconsulted before installation.

Please note that these instructions are guidelines only and in no way supersede any construction or installation standards.

ATTENTION• There is potential danger of electrical shock when operating electrical components.• Make sure power is turned off before installation.• Allow for heat dissipation and adequate ventilation.

LED Light Engine Designed for BL fiberOPTIC36W, Mono or Polychromatic, DMX512

BL fiberSOURCE LV3 Series

Ceiling Height

8FT10FT15FT20FT

Density (No. Points per SQ.FT)

Light Average Full Dense

“Starfield” Coverage

3211

4322

6543

10865

BL fiberOPTIC MC SERIESMicro-Fiber Bundle Layout with LV3 Series

For more information, please download the BL LIGHTING catalogue

BL LIGHTING. ILLUMINATE EVERYTHING111 - 8838 Heather St. Vancouver, BC. Canada. V6P 3S8 P: 1-604-874-4405 F: 1-604-321-0445 E: info@bllighting.com Copyright © 2017 BL INNOVATIVE LIGHTING. All Rights Reserved.

PROJECT CLIENT TYPE

Solid State Lighting is sensitive to power fluctuationsSurge protection is highly recommended for all LED lighting products and should be on a designated circuit to protect against premature failureLack of surge protection may void your warranty

bllighting.com

INSTALLATION - D04 -

Printed

Local building and electrical codes should beconsulted before installation.

Please note that these instructions are guidelines only and in no way supersede any construction or installation standards.

ATTENTION• There is potential danger of electrical shock when operating electrical components.• Make sure power is turned off before installation.• Allow for heat dissipation and adequate ventilation.

LED Light Engine Designed for BL fiberOPTIC36W, Mono or Polychromatic, DMX512

BL fiberSOURCE LV3 Series