CISCO ROUTER BY Mark Sullivan Nancy Tung Xiao Yan Wu

CISCO ROUTER

BY Mark SullivanNancy TungXiao Yan Wu

Agenda

Cisco Background What is a Router What is Switch Router Command Router Configuration

Cisco Background

The worldwide leader in networking for the Internet.

Internet Protocol-based (IP) networking solutions

provides the broadest line of solutions for transporting data, voice and video

Cisco Security

Cisco equipment ensure that networks both public and private

operate with maximum performance

flexibility security VPN (Virtual Private Network) Encryption

Remote Office

Router

A router is located at the gateway

it routes packets as they travel from one network to another network(s).

A router can be either a hardware device or a software application

The router is connected to at least two networks

Cisco 4000

Router Interfaces

The console port is a management port used to provide out-of-band access to the router. It is used for the initial configuration of the router, monitoring, and disaster recovery procedures. To connect to the console port, a rollover cable and a RJ-45 to DB-9 adapter are used to connect a PC. Cisco supplies the necessary adapter to connect to the console port.

Switches

segments the Local Area Network (LAN)

by directing the data flow and determines the route of packets

a switch performs the layer 2 or Data-Link layer function.

Switch Interface

Switch Port Connections

Router Connection To connect the PC to a router: Configure terminal emulation software on the PC

for: The appropriate com port 9600 baud 8 data bits No parity 1 stop bit No flow control

Connect the RJ-45 connector of the rollover cable to the router console port.

Connect the other end of the rollover cable to the RJ-45 to DB-9 adapter.

Attach the female DB-9 adapter to a PC.

Connect the Console Cable

1. Connect the light-blue console cable to the light-blue port labeled CONSOLE on the rear panel of the router.

2. Connect the other end of the light-blue console cable to an RJ-45 adapter.   Use either the RJ-45-to-DB-9 adapter or the RJ-45-to-DB-25 adapter, depending on

your local terminal or PC.

3. Attach the adapter to a serial port on a terminal or PC running emulation software to allow router configuration.

Connect Ethernet

Two Router Configuration

Home OfficeMain Office

Network Connections

Office Home

Servers

Office in Home

Bedroom Connection

Router Basic Topology

Network Configuration Modes

Hostname Command

Router#hostname HomeOffice

HomeOffice(config)#

Configuration Commands

Interface Commands

Interface Commands

Router Protocol Command

HomeOffice#router rip network ip address

network ip address

Summary

Cisco Routers technology links many of the worlds communication networks.

Cisco.com

Cisco Academy

http://cisco.netacad.net

2600 Router

6500 Switch