View
21
Download
0
Category
Preview:
Citation preview
Disassembling Axis 214 PTZ Camera(English/Slovenščina)
How to disassemble Axis 214 PTZ camera.
Written By: lukahlastec
Disassembling Axis 214 PTZ Camera (English/Slovenščina) Draft: 2019-07-23Guide ID: 28824 -
This document was generated on 2019-09-20 12:55:31 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 7
INTRODUCTION
How to disassemble Axis 214 PTZ camera.
TOOLS:Pro Tech Toolkit (1)
Disassembling Axis 214 PTZ Camera (English/Slovenščina) Draft: 2019-07-23Guide ID: 28824 -
This document was generated on 2019-09-20 12:55:31 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 7
Step 1 — Disassembling Axis 214 PTZ Camera (English/Slovenščina)
4 screws
Step 2
7 screws
Disassembling Axis 214 PTZ Camera (English/Slovenščina) Draft: 2019-07-23Guide ID: 28824 -
This document was generated on 2019-09-20 12:55:31 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 7
Step 3
Remove (4) Phillips screws.
Carefully disconnect the ribbon connector.
Odklopi konektor.
Step 4
Remove (4) Phillips screws. 4 screws, težko odšraufati
If replacing the logic board, remove (2) cables at the connectors. Odključi priključke (označi katerije kateri !
At the underside of the logic board, disconnect the connector. Izključi konektor (na kontektorju sospredaj številke)
Disassembling Axis 214 PTZ Camera (English/Slovenščina) Draft: 2019-07-23Guide ID: 28824 -
This document was generated on 2019-09-20 12:55:31 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 7
Step 5
Gently press back the plastic clip at both sides. Izključi plastični zatič na obeh straneh
Remove 2 screws. 2 šraufa.
Remove (3) Phillip screws. 3 šraufi (2+1)
Step 6 — Odključitev heada
Remove (4) Phillips screws. 4x vijak.
Carefully disconnect ribbon and flex cables. 2x flat in odstraniš glavo iz kletke (v bistvu asmo 1 flat!
Disassembling Axis 214 PTZ Camera (English/Slovenščina) Draft: 2019-07-23Guide ID: 28824 -
This document was generated on 2019-09-20 12:55:31 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 7
Step 7
Remove (2) Phillip screws. 2šraufa(samo odtegneš, pustiš notri).
Remove (1) protective clip. 1varovalna sponka.
Step 8
Remove 2 screws one on each side. 2 šraufa
Turn the latch mechanism to the right. obrni zatič na desno.
Disassembling Axis 214 PTZ Camera (English/Slovenščina) Draft: 2019-07-23Guide ID: 28824 -
This document was generated on 2019-09-20 12:55:31 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 7
To reassemble your device, follow these instructions in reverse order.
Step 9
It is difficult to disassemble.
Težko za razstaviti
Step 10
Remove (4) recessed screws. 4 šraufi, odstraniš plastiko, pazi na flat kabel.
Disconnect flat Ribbon Cable. Flat kabel.
Disassembling Axis 214 PTZ Camera (English/Slovenščina) Draft: 2019-07-23Guide ID: 28824 -
This document was generated on 2019-09-20 12:55:31 PM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 7 of 7
Recommended