Factory Wiring Harness- Dodge Ram- Scosche

In no event shall Scosche be responsible forclaims beyond the replacement value of thedefective product, or in any way liable or re-sponsible for consequential or incidentaldamages.

FACTORY STEREOCONNECTOR

Using the appropriate Scosche "Car StereoConnector" to adapt to your vehicle'sFactory Wiring Harness Connector inconjunction with the "Factory StereoConnector" will eliminate the need to cutany of your factory wires.

©1998 SCOSCHE INDUSTRIES, INC. 9/98

If you have any questions, you may call our tollfree technical help line at: 1-800-621-3695, x3

Helpful Hints:� The wiring colors of the Factory Stereo Connector

may be different from the wiring colors found on yourstereo.

� Refer to the section entitled "Wire Color Codes"found in this instruction to verify all the wirefunctions. Always use a test light and/or voltagemeter to test wire functions first.

WIRING INSTRUCTIONS:1. Using a test light or voltage meter, determine wire

functions for each of the factory stereo wires foundin your vehicle's dash. i.e. Determine which wire is12 volt constant, 12 volt switched, ground, dimmer,etc.

2. Determine which wires are positive and negative foreach speaker in the vehicle.

3. Disconnect the negative battery cable from thebattery to avoid any short circuits.

4. Match and connect the appropriate wires from theFactory Stereo Connector to the appropriate wiresin the dash previously determined in steps one andtwo.

5. Verify that all wires of the Factorty StereoConnector are connected to the proper wires inyour vehicles dash, and that all connections aresecure.

6. Tape all unused wires to prevent short circuiting.7. Reconnect the negative battery cable to the battery.8. Insert the Stereo Connector into the stereo.9. Check all functions including the fader and balance.

Refer to your stereo owners manual if necessary.

FACTORY HARNESS

WIRE COLOR CODES:The Factory Color Codes Are Not Available At ThisTime. Please Refer to The PIN Location Below.

7 WIRE PLUG (BLACK)

PIN #

1. = Power Antenna

2. = Left Rear Positive (LR+).

3. = Right Rear Positive (RR+).

4. = Left Front Positive (LF+).

5. = Right Front Positive (RF+).

6. = Left Rear Negative (LR-).

7. = Right Rear Negative (RR-).

7 WIRE PLUG (GRAY)

PIN #

8. = Not Used.

9. = Left Front Negative (LF-).

10. = Right Front Negative (RF-).

11. = Not Used.

12. = Illumination/Dimmer.

13. = 12 Volt Ignition/Switched (12V+).

14. = 12 Volt Battery/Constant (12V+).

CHRYSLER

1995-UPCIRRUS

1993-UPCONCORDE

1983-84 E CLASS

1979-UPFIFTH AVENUE

1981-UPIMPERIAL

1994-UPLHS SEDAN

1984-86 LASER

1984-UPLE BARON

1995 NEON

1979-UPNEW YORKER

1995-UPSEBRING

DODGE

1983-88 600 ES

1985-89 ARIES

1995-UPAVENGER

1984-UPCARAVAN

1983-87 CHARGER

1987-UPDAKOTA

1984-UPDAYTONA

1977-89 DIPLOMAT

1988-UPDYNASTY

1993-UPINTREPID

1985-89 LANCER ES

1978-90 OMNI

1981-UPPICKUP,

FULL SIZE

7 WIRE PLUG (GRAY)

7 WIRE PLUG (BLACK)

1

2

3

4

5

6

7

8

9

14

13

12

11

10

DODGE (cont.)

1994-UPRAM TRUCK

1981-89 RAMCHARGER

1987-UPSHADOW

1989-UPSPIRIT

1995-UPSTRATUS

1984-UPVAN

EAGLE

1993-UPVISION

JEEP

1993-UPGRAND

CHEROKEE

WAGONEER

PLYMOUTH

1989-UPACCLAIM

1985-88 CARAVELLE SE

1980-89 GRAN FURY

1978-90 HORIZON

1995 NEON

1985-89 RELIANT

1987-UPSUNDANCE

1983-87 TURISMO

1984-UPVOYAGER

Scosche CR01 Wire ConnectorRecommended

Scosche CR01 Wire ConnectorRecommended