Firth HotBloc · Gr a de 3 0 0 40 b a r d ia Gr a de 5 0 0 70 b a r d ia m i n. l ap Se e N ot e S...

Gra

de 3

00 4

0 ba

r dia

Gra

de 5

00 7

0 ba

r dia

min

.lap

See

Not

eSe

e N

ote

See Note

Refer to NZS 4229 or specific design for dimension, reinforcing, and ground clearances

See Note

200 x 200 haunch

75mm minimum granular fill

Damp proof membrane

Interior plaster/finish asspecified

Horizontal reinforcement

Grout 17.5 MPa(except sea spray zones 25MPa)Vertical reinforcement central to cavity

100mm slab

Reinforcing meshConcrete (17.5 MPa)

Firth HotBloc®

Polystyrene

Exterior plaster/finish as specifiedwith applied waterproof coating

Finishedfloor level

Groundclearence

per E2/AS1D12

D12 ties @ 600ctrs.(lap 600 min.)

www.firth.co.nzDisclaimer : This information is intended solely as a guide for use of Firthproducts. Before using a Firth product you should ensure that the product issuitable for use in the specific application. Nothing in this informationconstitutes a statement of fitness for particular purpose - appropriate expertadvice should always be obtained. Firth makes no warranty regarding the useof this information with non-Firth product.

© 2009 . The copyright of this document isthe property of Firth and shall not bereproduced, copied, loaned or disposed ofdirectly, or indirectly, nor used for anypurpose other than that for which it isspecifically furnished without prior consent.For Technical Advice: Ph. 0800 800 576

Firth HotBlocEdge Thickened Slab Detail 103103_edge_thickened .dwg

February 2009Scale 1:10

®

Notes:

Refer to CCANZ CO.01:2011 for situations where a floor rebate is required.••

®

• If a rebate is required increase footing width to block width +150mm.