Restore your roof with anASTEC® Re_PlyTM System

and get more roof for less money!

~,J wJt ~ ~ £A~I/O~;;11iw ~- ..~t~~ APPROVED

Add ASTEC Advantages to Your Roof

Add aWind Breaker ­An ASTEC Re-Ply surfaceseals all joints. laps. andfas eners under a monolithicseamless barrier that strongwinds. and driving rain orhail. virtually cannot rattle,lift. or erode.

Add a Solar Shield ­Ceramic and titanium-basedASTEC Re-Ply roofing surfaceshave very high reflectivity and heatdissipation - reducing heat andharmful UN rays on your building.+- This infrared aerial photographindicates tlJOt the ASTEC Re-Plyshielded surface is 50°F coolerthan the unshielded roof.

Add a RenewableWarranty ­Every ASTEC Re-Ply Systemis Warranted for ten years afterapplication. As the warranty periodends. you may chose to have yourASTEC Re-Ply surface inspected.cleaned. restored. and the warrantyrenewed for another ten years.(Check all the benefits on the ASTECRe-Ply I O-Year Renewable Warranty.)With periodic ASTEC inspectionsand maintenance - this could bethe lost roof you will ever need!

Add a CorrosionBarrier -ASTEC Re-Ply roofing surfacesare virtually impervious toocean salt spray, acid rain.and many other airbornecorrosives and abrasives.I is formulated to withstandvery hostile environments.

"EI Nino produced some of the heaviest rainswe've seen in this part of the country for many years.

And no problems from the (ASTEC) root ... "

The ASTEC Re-Ply System is fluid-applied in multiple layers.The seamless, cured membrane outperforms ordinary roofing surfaces

over a broad range of key test characteristics (see back cover.)

ASTEC® Re_PlyTM Systemfor Metal Roofs

Apply Final Layer:Flow on a second layer of ASTEC #900 CeramicFinish for Metal. This final application will createa seamless, titanium-white surface of hlghly­reflective. ceramic-embedded roofing that remainswaterproof. pliable, and virtually ImperVIOUSto airborne corrosives over years of hos Heenvironmental conditions.

Procedures will vary by rooftype and condition.Contact us, or visit

www.icc-astec.com for details.

Seal Roof:Flow on ASTEC WPM#9 Waterproof Sealerover all areas of caulking. reinforcing fabric, andfasteners to create a watertight base for the finalseamless layers.

Apply Core Layer:Flow on the first layer of ASTEC #900Ceramic Finish for Metal. It provides a tough,weathertlght. monolithic core layer. bonded overevery square Inch of the roof surface.

Prepare Surface:Remove scaling rust. and pressure washto achieve a clean. sound surface. Tightenor replace loose fasteners.

Seal Seams & Fasteners:Caulk open seams. Reinforce all seams.flashings. and penetrations with hightensile strength fabnc.

Encapsulate Corrosion:Apply ASTEC 8-16-71 Rust Control,speCially formulated to neutralize and haltfurther metal corrosion.

When the Anaheim Convention Center decided to fix theirsevere leaking and worsening corrosion problems, they chose the

monolithic ASTEC Re-Ply System to restore and enhance their unique metal roof."We looked at a variety of products, but nobody had a system like ASTEC. .. "

Improves Metal Roofs• Creates a seamless, weathertight barrier.• Eliminates rust and corrosion.• Reflects away heat and harmful U. V radiation.• Surpasses R19 heat gain testing.• saves big temperature control and cooling costs.• Greatly reduces thermal shock damage.• Improves appearance.• Eliminates roof replacement expenses.• Provides a 1O-Year Renewable Warranty.

•

Procedures will vary by rooftype and condition.Contact us, or visit

www.icc-astec.com for details.

Apply Core Layer:Flow on the first ASTEC Re-Ply Finishlayer. It will bond with the ASTEC Basesealer and provide a monolithic core baseFor the final surFace.

Apply Surface Layer:Flow on the Final ASTEC Re-Ply Finishlayer. The new surFace will be a seamless.titanium-white ply of a highly-reFlectiveroofing that is waterproof. pliable. andVirtually imperVIOus to airborne corrosivesover years of hostile environmentalconditions.

Prime and Seal Surface:Depending on the original compositesurface. Flow on one or two layers of eitherASTEC Base Sealer #8 for Rubber, orASTEC Base Sealer #4 for Aspl70lt.Both apply as Fluids. filling all cracks. andcuring as a seamless. pliable. membraneover the entire roof.

ASTEC® Re_PlyTM Systemfor Rubber & Asphalt Roofs

<0

Prepare Surface:Pressure wash the old surface to eliminateloose material. Repair substrate. blisters.and cracks as needed.

Seal Seams:Reinforce all roof. vent. duct. and flashingseams and laps with high tensile strengthfabric. saturate with the appropriate ASTECBase Sealer.

The asphalt roofing on this retail facility was restored to better-than­original condition by adding the advantages of the ASTEC Re-Ply System.The savings in cooling expenses alone will easily pay the cost of restorationover the life of the ASTEC Renewable Warranty.

Improves Composite Roofs• Creates a seamless. weathertight barrier.• Stays pliable and weathertight in all climates.• Withstands ponding water.• Resists fungi and algae growth.• Reflects away heat and harmful U V radiation.• Surpasses R19 heat gain testing.• Saves big temperature control and cooling costs.• Greatly reduces wind damage risk.• Improves appearance.• Eliminates roof replacement expenses.• Provides a 1O-Year Renewable Warranty.

ISO International Organizationfor Standardization

ISO. The source of ISO 9000,ISO 14000 and more than 14,000International Standards for business,government and society.

ISO. A network of national standardsinstitutes from 148 countries workingin partnership with internationalorganizations, governments. industry,business and consumerrepresentatives.A bridge between public andprivate sectors.

www.iso.ch

Registered by NSF-ISR

Provider of ISO 9000, ISO 14000.OS-9000 Management SystemsRegistration, and related trainingand publications.

www.nsf.org

THE FSCT Memberwww.coatingstech.org.

THE SOCIETY FOR PROTECTIVECOATINGS Memberwww.sspc.org.

"'DADEtCompliance Approved byMIAMI-DADE BUILDING CODE

www.miamidade.govlbuildingcode,

<§>APPROVED

FACTORY MUTUAL SYSTEMApproved

www.fmglobal.com

ASTEC®Systems Affiliations

Member of theNATIONAL ROOFINGCONTRACTORS ASSN.

www.nrca.net

Member of theROOF CONSULTANTS INSTITUTE

www.rci-online.org

Charter Member of theCOOL ROOF RATING COUNCIL

www.coolroofs.org

An ENERGY STAR Partner

www.energystar.gov

ASTEC Re_PlyT.Roofing Systems& Specialty Coatings

Manufactured byINSULATINGCOATINGSCORPORATIONICC is recognized as a worldleader in fluid-applied ceramiccool roofing technology,as represented by tilefollowing affiliations:

ASTEC® Re-PlyT. Systemsare products of:

D

D

Insulating Coatings Corporation - North103 Main StreetBinghamton. ew York 13905

Telephone: 1-800-223-8494Fax: 607-723-1700

Insulating Coatings Corporation - South956 South Highway 41Inverness. Florida 34450

Telephone: 1-800-345-5306Fax: 352-344-8370

Visit www.icc-astec.com for additional detailsYour ASTEC® Re-Ply'· Authorized Contractor:

COPYRIGHT 2006 INSULATING COATINGS CORPORATION GRA37·J06M