CUSTOMER HELP LINEUSA 800-323-4329 • Canada 800-245-8777

FMK550

MountingKit

Ford1995-10 CROWN VICTORIA1997-08 ECONOLINE VAN (Club Wagon)2001-07 ESCAPE2000-05 EXCURSION1998-06 EXPEDITION (Non Navigation)1995-05 EXPLORER2000-06 EXPLORER Sport Trac1999-04 F-SERIES TRUCKS2004 F-150 (Heritage Only)2001-04 MUSTANG1995-11 RANGER1999-03 WINDSTARFord Commercial Vehicles1999-08 E-1501997-08 E-2501999-08 E-3501999-08 E-4502002-04 F-2502002-04 F-3502002-04 F-450

VEHICLE APPLICATIONSFord Commercial Vehicles Cont.2002-04 F-5502002-07 F-6502003-04 F-750Lincoln2003-05 AVIATOR2001-02 BLACKWOOD1995-97 CONTINENTAL1995-98 MARK VIII1999-06 NAVIGATOR1995-02 TOWN CARMazda1995-10 B-SERIES P/UʼsMercury2001-02 COUGAR (flat face radios only)1995-10 GRAND MARQUIS1997-05 MOUNTAINEER2003-04 MARAUDER2005-07 MARINER

iFMK550 ©2015 AMERICAN INTERNATIONAL INDUSTRIES, INC. TECH Ver. 11/14 PRINT Ver. 01/15

WWW.AIUS.NET2500 East Francis Street Ontario, CA 91761, U.S.A.

USA Sales (800) 336-6500Canada Sales (888) 922-3006

For information about other American International automotiveaccessories visit our website at:

http://www.aius.net

FORD Page1995-10 Crown Vic * 31997-08 Econoline Van (Club Wagon) * 62001-07 Escape * 72000-05 Excursion * 61998-02 Expedition * (Non Navigation) 72003-06 Expedition (Non Navigation) 51995-01 Explorer (All) * 82002-05 Explorer 41999-03 F-Series Trucks (All) * 62004 F-150 Heritage model only * 62001-04 Mustang 41995-11 Ranger * 61999-03 Windstar * 6

LINCOLN Page2003-06 Aviator 91995-97 Continental * 31995-98 Mark VIII * 31999-03 Navigator * 71995-02 Town Car * 3MAZDA1995-10 B-Series P/U * 6MERCURY2001-02 Cougar * 81995-10 Grand Marquis * 32003-05 Marauder * 32005-07 Mariner * 71997-01 Mountaineer * 82002-05 Mountaineer 4

THIS KIT CONTAINS

MAIN BRACKET

ISO TRIM RING

ISO MOUNTINGBRACKETS REAR

SUPPORT

SPACER NUBS

TABLE OF CONTENTS

NOTES

Due to variances on Ford, Lincoln,Mercury and Mazda radio openings,this installation kit has been uniquelydesigned with spacer nubs. Thesespacer nubs take up the playbetween the installation kit andmounting locations for a tighter fit.

Spacer nubs may have to be fileddown or cut off to allow locking tabsto fully engage on some vehicles.(i.e. Ford Ranger)

* These vehicles require Ford radio removal tools to removefactory radio. American International part #URT-460

NOTES:

1 10

MOUNTING SPACERS

Optional: ISO trim ring may be usedin place of after-market radio’s trim ring.

ISO Trim Ring(Use Optional)

ISO MOUNT ASSEMBLY INSTRUCTIONS1. Attach left and right mounting brackets to rear of kit as shown in Fig. B and secure

to back of pocket using screws provided with kit.2. Insert ISO mountable radio between ISO mount brackets and loosely attach to sides

of radio using screws provided with radio when possible or screws supplied with kit.3. Attach ISO trim ring to face of kit.4. Slide radio forward or backward for desired look and tighten screws.

DIN MOUNT ASSEMBLY INSTRUCTIONSNOTE: Kit must be mounted in dash prior to bending tabs on sleeve1. Insert DIN sleeve from your new radio into the radio opening of the

installation kit as shown in Fig. A.2. Depress the tabs from inside the sleeves opening upward, outward, and

downward to secure the installation kit to the sub-dash.

Insert left and right ISO mountingbrackets into radio opening asshown in illustration and secureto back of pocket using screws provided

Fig. A

Fig. B

ISO Trim Ring(Use Optional)

Rear BracketSupport

Rear BracketSupport

9 2

Optional: ISO trim ring may be usedin place of after-market radio’s trim ring.

NOTES:2003-05 Lincoln Aviator

1. Carefully pry the top center Vent Panel assembly upward and remove.2. Remove the (2) 9/32 screws securing the top of the radio trim bezel.3. Carefully pry the lower sides of the radio trim bezel slightly forward to release and

remove the radio trim bezel.4. Carefully pry the clock/vent assembly below the radio forward, disconnect the

harness and remove clock/vent assembly.5. Remove the (2) 9/32 screws securing the radio to the sub-dash and save metal

bar for reinstallation.6. Carefully pull radio forward, disconnect the wire harnesses and antenna lead and

remove radio.

(Mounting Tabs)

NOTE: Adjust mounting kit up or down for bestfit, then tighten screws

*

2003-05 Aviator

1. Pocket must be on top.2. You must use the factory style rear support bracket (included).3. Attach a backstrap from the back of the pocket to the backstrap hole on your radio.

NOTES:

(Mounting Spacers)

1. Pocket must be on top for all vehicle applications.2. You cannot ISO mount on these applications.3. You must use the Din mounting sleeves on these applications.4. Remove the Mustang mounting tabs for these applications.

X XSpacer Nubs

* See Notes on Page 1

Remove Tabs

1. This kit only fits Cougar vehicles with a flat face Ford radio, not the curved type(i.e. Ford Focus style).

2. Remove the Mustang mounting tabs for this application.

1. Pocket can be mounted on the top or the bottom.2. Break off the top right locking tab of the kit. (As shown in Fig. A & B)3. These vehicles can only be ISO mounted if the pocket is on top.4. Remove the Mustang mounting tabs for these applications.

X

FIG A FIG B

Pocket on TopX

X

X XRemove Tabs

Remove Tabs

Spacer NubsSee Notes onPage 1

See Notes on Page 1

Remove Tabs

X

XX

Pocket on Bottom

NOTE: See page 4 for 2002-05 Explorer/Mountaineer instructions.

1995-10 Ford Crown Vic1995-97 Lincoln Continental1995-98 Lincoln Mark VIII1995-02 Lincoln Towncar1995-10 Mercury Grand Marquis2003-07 Mercury Marauder

NOTES:

NOTES:2001-02 Mercury/Cougar

NOTES:

1995-01 Explorer (all models)1997-01 Mountaineer

3 8

1 For Stickshift models-Twist off the shift knob (counter clockwise)and remove.2 Gently lift up on the trim around the gear shift lever, disconnect the harness and

slide the rubber boot off the end of the shifter knob.3 Gently unsnap the trim bezel from around the radio, disconnect the harnesses and

remove the trim bezel.4 Remove the (4) 9/32 screws securing the radio to the subdash.5 Slide the Radio forward, disconnect the harnesses an antenna lead and

remove the radio

1 Gently pry outward on dash trim panel & remove.2 Remove (2) screws securing radio to sub-dash.3 Pull radio forward, disconnect wire harness & antenna lead & remove radio.

2001-04 Mustang

(Mounting Tabs)**Mustang

NOTE: Position mounting holes on kit to the topfor Explorer / Mountaineer application.

NOTE: Position mounting holes on kit to thebottom for Mustang application.

*

**

*Explorer /Mountaineer

2002-05 Explorer /2002-05 Mountaineer

1. This kit may be mounted in vehicle dash with pocket on top or bottom.2. You may have to remove the factory rear support bracket, or modify the top of the

subdash to allow for the radio or pocket to fit properly.3. Remove the Mustang mounting tabs for these applications.

1. Pocket can be on top or bottom.2. File the top right side of the radio subdash opening so the side is straight up

and down.3. Remove the Mustang mounting tabs for this application.

XX

XX

Remove Tabs

Remove Tabs

Spacer Nubs*See Noteson Page 1

Spacer Nubs*See Noteson Page 1

7 4

NOTES:

1998-02 Ford Expedition1997-02 Lincoln Navigator

2001-07 Ford Escape2005-07 Mercury Mariner

NOTES:

DASH DISASSEMBLY:2001-04 Ford Mustang

DASH DISASSEMBLY:

2002-05 Ford Explorer/Mercury Mountaineer

NOTES:(Mounting Spacers)

1. Pocket must be on top.2. Attach mounting spacers to backside of mounting tabs (if desired).3. Attach a backstrap from the back of the pocket to the backstrap hole on your radio.

1. Set the emergency brake.2. Remove the (2) 9/32 screws from above the instrument gauges.3. Lower the steering column all the way down.4. Carefully pry outward on the dash trim bezel.5. Disconnect the wire harnesses from the headlamp switches and the climate controls

and remove the panel.6. Remove the (2) 9/32 screws securing the factory radio to the sub-dash.7. Pull the radio forward, disconnect the wire harnesses and antenna lead

and remove radio.

(Mounting Tabs)

NOTE: Position mounting holes on kit to thebottom for 2003-06 Expedition application.

*

2003-06 Expedition

1. This kit may be mounted in vehicle dash with pocket on top or bottom.2. For all ISO Mount applications, you must use the factory style rear support bracket.3. Remove the Mustang mounting tabs for these applications.

XX

Remove Tabs

Spacer Nubs* See Notes on Page 1

DASH DISASSEMBLY:

2003-06 Ford Expedition w/out Factory Navigation

NOTES:

NOTES:

1997-08 Ford Econoline Van (Club Wagon)2000-05 Ford Excursion2004 Ford F-150 Heritage1999-03 Ford F-Series (All)1995-11 Ford Ranger1999-03 Ford Windstar1995-10 Mazda B-Series P/U

5 6

(Mounting Spacers)

1. Pocket must be on top.2. Attach mounting spacers to backside of mounting tabs (if desired).3. Attach a backstrap from the back of the pocket to the backstrap hole on your radio.