4
8/9/2019 01 41 00 - Regulatory Requirements http://slidepdf.com/reader/full/01-41-00-regulatory-requirements 1/4 Toronto Transit Commission CONTRACT A29-1 Section 01 41 0 REGULATORY REQUIREMENTS Page 1 CODES AND STANDARDS 1 1 General: 1 Contract forms, codes, Specifications, standards, manuals, and installation, application an maintenance instructions referred to in the Specifications, unless otherwise specified an unless otherwise stated in the governing building code, shall be the latest publishe editions at the date of the Contractor s Tender submission 2 Conform to Contract forms, codes, Specifications, standards, manuals, and installation application and maintenance instructions referred to in the Specifications, in whole or i part, as specifically stated in the Specifications 3 In case of conflict between individual requirements, comply with the most demanding an stringent requirement. 4 If there is a question regarding whether any Product or system is in conformance wit applicable requirements, the Commission reserves the right to have such Products o systems tested at the Contractor s cost to prove or disprove conformance 5 The cost for testing will be borne by the Commission in the event of conformance with the Contract Documents, or by the Contractor in the event of non-conformance. 1 2 Definitions: 1 Refer to the Contract Documents and the Ontario Building Code for definitions applicable to the Contract. 1 3 Acronyms: 1 Refer to the Ontario Building Code and to the following list for descriptions o acronym applicable to the Contract Documents. AABC AAMA ABMA AREMA ASHTO ACI ASME ADA ACNBC AFBMA AHRI AlEE A SI AMCA AMEU ANSI APTA Aluminum Association Associated Air Balance Council American Architectural Manufacturers Association (USA) American Bearing Manufacturers Association American Railway Engineering and Maintenance-of-Way Association American Association of State Highway and Transportation Officials American Concrete Institute American Society of Mechanical Engineers Americans with Disabilities Act Associate Committee of the National Building Code Anti-Friction Bearing Manufacturer s Association Air-Conditioning, Heating, and Refrigeration Institute American Institute of Electrical Engineers American Iron and Steel Institute Air Moving Conditioning Association Association of Municipal Electric Utilities American National Standards Institute The American Public Transportation Association

01 41 00 - Regulatory Requirements

Embed Size (px)

Citation preview

Page 1: 01 41 00 - Regulatory Requirements

8/9/2019 01 41 00 - Regulatory Requirements

http://slidepdf.com/reader/full/01-41-00-regulatory-requirements 1/4

Toronto Transit

Commission

CONTRACT A29-1

Section 01 41 0

REGULATORY REQUIREMENTS

Page

1 CODES AND STANDARDS

1 1

General:

1 Contract forms, codes, Specifications, standards, manuals, and installation, application an

maintenance instructions referred to in the Specifications, unless otherwise specified an

unless otherwise stated

in

the governing building code, shall be the

latest

publishe

editions at the date of the Contractor s Tender submission

2 Conform to Contract forms, codes, Specifications, standards, manuals, and installation

application and maintenance instructions referred to in the Specifications, in whole

or

i

part, as specifically stated

in

the Specifications

3

In case of conflict between individual requirements, comply with the most demanding an

stringent requirement.

4 If there is a question regarding whether any Product or system is

in conformance

wit

applicable requirements, the Commission reserves the right to have such

Products o

systems tested at the Contractor s cost to prove or disprove conformance

5

The cost for testing will be borne by the Commission in the event of conformance with the

Contract Documents, or by the Contractor in the event of non-conformance.

1 2

Definitions:

1

Refer to the Contract Documents and the Ontario Building Code for definitions applicable to

the Contract.

1 3 Acronyms:

1

Refer to the Ontario Building Code and to the following list for descriptions

o

acronym

applicable to the Contract Documents.

AABC

AAMA

ABMA

AREMA

ASHTO

ACI

ASME

ADA

ACNBC

AFBMA

AHRI

AlEE

A SI

AMCA

AMEU

ANSI

APTA

Aluminum Association

Associated Air Balance Council

American Architectural Manufacturers Association (USA)

American Bearing Manufacturers Association

American Railway Engineering and Maintenance-of-Way Association

American Association of State Highway and Transportation Officials

American Concrete Institute

American Society of Mechanical Engineers

Americans with Disabilities Act

Associate Committee of the National Building Code

Anti-Friction Bearing Manufacturer s Association

Air-Conditioning, Heating, and Refrigeration Institute

American Institute of Electrical Engineers

American Iron and Steel Institute

Air Moving Conditioning Association

Association of Municipal Electric Utilities

American National Standards Institute

The American Public Transportation Association

Page 2: 01 41 00 - Regulatory Requirements

8/9/2019 01 41 00 - Regulatory Requirements

http://slidepdf.com/reader/full/01-41-00-regulatory-requirements 2/4

Section

141

REGULATORY REQUIREMENTS

Page2

Toronto Transit Commission

CONTRACT A29 1

AREA

ARI

ASH RAE

ASME

ASPE

ASTM

AWMAC

AWS

AWWA

BHMA

CAC

CAN

CCA

eeo

CCMC

CEC

CEMA

CGA

CGSB

CISC

CMHC

CPCA

CPMA

CPCI

CRCA

CSA

es

CSI

CSSBI

CTC

cUL

cULus

CWB

w

EEMAC

ESA

M

FS

GAMA

GANA

HRAI

lAO

American Railway Engineering Association

Air-Conditioning and Refrigeration Institute

American Society

of

Heating, Refrigeration and Air-Conditioning Engineers

American Society of Mechanical Engineers

American Society of Plumbing Engineers

American Society

for

Testing and Materials

Architectural Woodwork Manufacturers Association

of

Canada

American Welding Society

American Water Works Association

Builders Hardware Manufacturers Association

Cement Association of Canada

National Standard of Canada

Canadian Construction Association

Canadian Construction Documents Committee

Canadian Construction Materials Centre

Canadian Electrical Code

Canadian Electrical Manufacturers Association

Canadian Gas Association

Canadian General Standards Board

Canadian Institute

of

Steel Construction

Canada Mortgage and Housing Corporation

Canadian Paint and Coatings Association

Canadian Paint Manufacturers Association

Canadian Precast/Prestressed Concrete Institute

Canadian Roofing Contractors Association

Canadian Standards Association

Construction Specifications Canada

Construction Specifications Institute (USA)

Canadian Sheet Steel Building Institute

Canadian Transport Commission

Underwriters Laboratories classification mark indicating that the Product

has

been evaluated to meet Canadian safety requirements

Underwriters Laboratories classification mark indicating that the Product has

been evaluated to meet both Canadian and

US

safety requirements

Canadian Welding Bureau

Canadian Wood Council

Electrical and Electronic Manufacturers Association of Canada

Electric Safety Authority

Factory Mutual

Federal Specifications and/or Federal Standards (USA)

Gas Appliance Manufacturers Association

Glass Association of North America

Heating, Refrigerating and Air-Conditioning Institute of Canada

Insurance Advisory Organization of Canada

Page 3: 01 41 00 - Regulatory Requirements

8/9/2019 01 41 00 - Regulatory Requirements

http://slidepdf.com/reader/full/01-41-00-regulatory-requirements 3/4

Toronto Transit Commission

CONTRACT A29-1

Section 1 41 0

REGULATORY REQUIREMENTS

Page

IEC

IEEE

ISA

ISO

MIL

MPI

MOE

MSS

MTO

NAAMM

NBC

NEBB

NEMA

NETA

NFC

NFPA

NHLA

NICEIC

NLGA

NRC

NSC

OBC

OESC

OFC

OFM

OH

OHBDC

OHSA

OIRCA

OPCA

OPSS

OTM

OWRA

PAL CAN

PEl

PEO

sec

SJI

SMACNA

SSPC

TEMA

TRCA

TTMAC

TS

TSSA

International Electrotechnical Commission

Institute of Electrical and Electronic Engineers

Instrumentation Society

of

America

International Organization for Standardization

Military Specifications (Naval Publications and Forms Centre) USA)

Master Painters Institute

Ontario Ministry

of

the Environment

Manufacturer s Standardization Society

Ministry of Transportation Ontario

National Association of Architectural Metal Manufacturers

National Building Code

National Environmental Balancing Bureau

National Electrical Manufacturer s Association (USA)

International Electrical Testing Association (USA)

National Fire Code

of

Canada

National Fire Protection Association

National Hardwood Lumber Association (USA)

National Inspection Council for Electrical Installation Contracting

National Lumber Grades Authority

National Research Council

of

Canada

National Standards

of

Canada

Ontario Building Code

Ontario Electrical Safety Code

Ontario Fire Code

Ontario Fire Marshal

Ontario Hydro

Ontario Highway Bridge Design Code

Occupational Health and Safety Act and Regulations for Construction Projects.

Ontario Industrial Roofing Contractors Association

Ontario Painting Contractors Association

Ontario Provincial Standard Specification

Ontario Traffic Manual

Ontario Water Resources Act

Program for the Accreditation of Laboratories - Canada

Porcelain Enamel Institute

Professional Engineers of Ontario

Standards Council

of

Canada

Steel Joist Institute

Sheet Metal and Air-Conditioning Contractors National Association

Steel Structures Painting Council

Tubular Exchange Manufacturer s Association

Toronto Regional Conservation Authority

Terrazzo, Tile and Marble Association of Canada

City

of

Toronto Transportation Services

Technical Standards and Safety Authority

Page 4: 01 41 00 - Regulatory Requirements

8/9/2019 01 41 00 - Regulatory Requirements

http://slidepdf.com/reader/full/01-41-00-regulatory-requirements 4/4

Section 0141 00

REGULATORY REQUIREMENTS

Page

ULC Underwriters Laboratories of Canada

UL Underwriters Laboratories (USA)

WHI lntertek (Warnock Hersey)

END OF SECTION

Toronto

Transit

Commission

CONTRACT A29-1