1600 Series1600 SeriesOperation Operation

(See Installation and Operation Manual for detailed instructions)(See Installation and Operation Manual for detailed instructions)

2

FoamPro 1600 SeriesFoamPro 1600 Series

• Fully automatic• Class A foam ONLY• Proportions

between 0.1% to 1%

• Flowmeter standard (1", 1-1/2" or 2" tee)

• Operators control panel

3

WaterTank

WaterPump

Flowmeter

FoamTank

Line Strainer

Electronic DirectElectronic DirectInjection ProportionerInjection Proportioner

Check Valves

MultipleDischarges

4

• Controller includes:– Operating instructions– On/Off switch– Injection rate control

– Adjustable from 0.1%-1.0% – System Status Light

Features And OperationsFeatures And Operations

5

• System Status Light Codes:– Light flashes then goes out

– System ready to operate– One flash per second

– Simulated flow mode engaged– Remove power;

disengaged automatically– Solid light

– No concentrate– Two flashes per second

– Concentrate level low– 5 flashes per second

– Electrical error

Features And Operations Features And Operations (cont.)(cont.)

6

Motor driver module Circuit

breaker switch

“UP” for normal

operation

Simulated flow

momentary switch. Up

once, engages. Up again,

disengages

Features and Operations Features and Operations (cont.)(cont.)

7

• Enter “SIMULATED FLOW”

• Valve to “CAL/FLUSH”• Turn panel switch “ON”• Run pump until

concentrate flows from dump line

Purging AirPurging Air

8

• Turn control panel to “OFF” position

• Return valve to “INJECT”

• Exit “SIMULATED FLOW” by switching momentary switch up

Purging Air Purging Air (cont.)(cont.)

9

• Foam concentrate pump – Grease fitting every 8 hours of

operation

• Foam concentrate strainer – Clean out regularly– If little or no foam concentrate is

injected while system is running, check for clogged strainer

– Purge air from foam pump afterwards

MaintenanceMaintenance