7/25/2019 3239F592T
2/2
No adjustments to be made unless otherwise stated.
.
ISO OVERCHECK PROCEDURE
23. Timing S/C For validation:
Indexing tool set to 330.0 0.5
24. Priming (C) 200 Obtain delivery from all injectors
and backleak.
Cycle pump between 750 rpm and 800 rpm 5 times
(to remove air from Governor unit).
25. Shut-off - (C) 200 De-energise solenoid, wait 5
seconds.Solenoid Max. 2.0 mm3/st.
Stop test machine.
26. Delivery (C) 150 Minimum 40.0 mm3/st.
27. Stabilisation (C) 750 Run pump for 3 minutes to
stabilise.
50Hz Governor settings/checks only, tests 28 to 32 .
28. Delivery (C) 750 122 to 128 mm3/st.
29. Delivery (C) 775 86 to 101 mm3/st.
30. Delivery (C) 790 Maximum 20.0 mm3/st.
31. Delivery (C) 820 Maximum 5.0 mm3/st.
32. Advance - (C) 750 0.8to 1.2 49
13mm/3st.Light load Use throttle actuator tool.
60Hz Governor settings/checks only, tests 33 to 36 .
33. Delivery (C) 900 Minimum 115 mm3/st.
34. Delivery (C) 925 90 to 110 mm3/st.
35. Delivery (C) 945 Maximum 25.0 mm3/st.
36. Delivery (C) 960 Maximum 5.0 mm3/st.
