-
7/29/2019 50014 Throttle Control
1/11
EXIT
-
7/29/2019 50014 Throttle Control
2/11
Throttle control
Job No.
Adjusting control linkage
Removal and installation of accelerator pedal with front wall
mounting - 3 1 5Removal, installation and adjustment of cable
325Removal and installation of accelerator pedal 330Lubricating
control linkage and control shaft 335
EXIT
-
7/29/2019 50014 Throttle Control
3/11
Adjusting control
Control linkage and cable
cable (30)
Connecting rod (2)
Connecting rod (8)
cable (30)
check for easy operation and evidence of bending.
Renew parts if necessary.
disconnect. To do so, press off plastic clips
(arrow).
disconnect. Check if throttle valve rests against
idle stop. Reconnect connecting rod without
tension. Adjust so that the roller (15) rests against
the end stop without tension in the slotted link arm
adjust to approx. 155 mm and connect. Measured
from center to center of the ball socket.connect. The nipple
(26) of the cable
(30) must contact the compression spring (27)
without tension. Adjust cable (30) from the
vehicle inside bv means of adiustino nut (32).
3 0. 1 1 I I
EXIT
-
7/29/2019 50014 Throttle Control
4/11
-
7/29/2019 50014 Throttle Control
5/11
Model
3 0. 1 1 I I
EXIT
-
7/29/2019 50014 Throttle Control
6/11
-
7/29/2019 50014 Throttle Control
7/11
with cruise control
Check if the final control element contacts the
idle speed stop of the cruise control. To do so,
disconnect ( 2 1) and press the lever of
the control element clockwise against the idle
speed stop. When connecting the ( 2 1)
ensure that the lever of the control element is
lifted approx. mm above the idle speed stop.
Adjust pull rod if necessary.
3 0. 1 1 I I
EXIT
-
7/29/2019 50014 Throttle Control
8/11
-
7/29/2019 50014 Throttle Control
9/11
-
7/29/2019 50014 Throttle Control
10/11
-
7/29/2019 50014 Throttle Control
11/11
Lubricating control linkage and control shaft
Lubricating
Following each engine wash and enginecompartment conservation,
lubricate with an oil
can all bearing points, all control levers and
joints of the control linkage.
The cable is maintenance-free and need
not be lubricated.
On vehicles in @-version only the following
hydraulic oils may be used:
hydraulic fluid
Mobil Aero
Shell Aero fluid 4
3 0. 1 1 I I
EXIT
