The European Transmission Parts Warehouse
www.automaticchoice.comAutomatic Choice Europe BV, De Schutterij
19, 3905 PJ Veenendaal, The Netherlands,
tel: +31 (0)318 590591 fax: +31 (0)318 590177 e:
[email protected]
C h o i c e N e w sDECEMBER 2015
Some units are now being fitted with what is called an NDTH
hydraulic distributor, this can be identified by three notches cut
out of the separator plate as shown in the illustration below.
It is important that this type of hydraulic distributor, our
part number DPO.VB03 is matched to the later style E1 Teflon
sealing rings with overlapping joint, our part number DPO.SSR05,
see illustration below.The early non NDTH hydraulic distributor our
part number DPO.VB02 must be matched to the early butt jointed
sealing rings, our part number DPO.SSR02, see illustration
below.
Late type with overlap joint Part No. DPO.SSR05
Early type with butt joint Part No. DPO.SSR02
As far as we are aware, as long as the correct combination of E1
sealing rings and hydraulic distributor are put together, either
combination will work in any version of transmission.It is very
important to make sure when fitting a new hydraulic distributor
that the correct type is being fitted, or if rebuilding the unit
that the correct sealing ring/hydraulic distributor combination is
used.Please be aware that mixing incorrect sealing ring and
hydraulic distributor combinations will without exception result in
premature transmission failure.
Due to revised pick-up times of our carriers we will close
around 14.00 on Thursday 24th of December and Thursday 31st of
December.
Please keep this in mind for your orders.
Important Rebuild Information for AL4/ DP0 Transmissions
**We wish you a wonderful Christmas with your family**
