Upload
norka34
View
238
Download
0
Embed Size (px)
Citation preview
7/28/2019 BNL-027
1/4
Earrings BNL-027Try Finger Tatting
For the pair of crme earrings you will need: about 3 - 4
yards of HY MARK Glace Thread or DMC #10 Cblia threadand164 light and60dark seed beads size 10.
For the pair of dark earrings you will need: about 3 - 4yards of HY MARK Glace Thread or DMC #10 Cblia threadand48 light and158dark seed beads size 10.
e-mail: [email protected] site: http://www.beanile.com
mailto:[email protected]://www.beanile.com/http://www.beanile.com/mailto:[email protected]7/28/2019 BNL-027
2/4
Earrings BNL-027
Symbols used through the pattern:
R ringCH chain1; 2; 3number of double stitches;
1'up' bead & 1'down' bead, both light;
1 light 'up' bead & 1dark 'down' bead;
1'up' bead & 1'down' bead, both dark;or 3'up' beads in a row;
or
2 light 'up' beads & 1dark 'down' bead
2'up' beads & one'down' bead, both dark;
5'up' beads in a row;8'up' beads in a row;
LJ lock join (join with the shuttle thread). close a ring or shape & tighten a chainRW reverse work
Please remember:
'up' beads are those on your knottingthread, they come either from the ball orfrom the left hand shuttle (meaning:from the loop or thread on your left hand);
'down' beads are always- always from the core thread(meaning: from the shuttle in your right hand).
- 2 -
7/28/2019 BNL-027
3/4
7/28/2019 BNL-027
4/4
Earrings BNL-027(mostly dark)
- Take about2yards of thread & 'needle' both tails.
- String12 light beads from one tail, these are your 'up'beads. Start at about 2 feet from the end of the tail.
R1 is the same for mostly dark and mostly light earrings
R1: 1 1 1 1.RWYou will pick up: 2dark 'down' beads when needed.Turn the closed the ring upside down.
- For the dark earring (picture below) string6 +7 +6 beads,these are your 'up' beads and should be on your left hand
R2: 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1.RW
You will pick up: 14 'down' beads as needed.
- String37 'up' beads from the other tail. Make the chain using the
shorter (your first) tail as a 'shuttle' and the longer tail as a 'ball'.19 'down' beads you will pick up one by one when needed.
CH: 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
1 1 1 1 1 1 1 1 1 1 1.LJ (lock join between rings 1&2).
- Cut the finished piece off leaving enough thread to tie andhide the tails.- Take another length of thread, 'needle' both tails, string the beads.- Repeat positions 2) through 5).
- 4 -