Vape on!

Clearomiser 101

Make sure youare filling fromthe right end

(tip: you fill BDC’s fromthe bottom & standard

clearomisers fromthe top!)

E-liquid inmouth

Don’t take long drags

(especially if using a low ohm clearomiser)

Don’t hold thebutton down for

too long(tip: turn it off in

your bag or pocket)

Don’t allowthe e-liquid

to run too low

Allow at least5 minutes for

the e-liquid to soak in

(If it’s a new coil)

Clean the clearomiserby running

water through it(allow to dry for

12 hours)

Change thecoil

It may be timefor a new

clearomiser

Did it work?

Burnt Taste

No

Does a differentclearomiserwork on the

battery?(If not, then it may be

a battery fault)

Clean battery& clearomiserconnection

points

Ensure coil isscrewed securily tothe base

Not gettingenough vape

Ensure thebattery is fullycharged and

turned on

Check for cracks

Have you leftyour

clearomiser ina too hot or toocold a place?(If so, leave it in aplace with a cool

temperature)

Ensure the rubber seals

have not shiftedor broken

Ensure theconnections

have not cross-threaded

Leaking

Ensure you have not

flooded yourclearomiser

(Got any liquid downthe centre tube)

Give the clearomiser

a flick

Remove base& blow

through mouth piece

Gurgling

www.ecigarettedirect.co.uk/ashtray-blog

www.ecigarettedirect.co.uk

A useful guide from the Ashtray Blog

*

*

*

**

BDC (bottom dual coil) clearomisers are filled from the bottom and have a replaceable coilKey: All steps marked with a are for BDC clearomisers only.*

Yes

Having problems with your clearomiser?Use this handy flowchart to diagnose and resolve issues - and get back vaping without delay!