Vape on!
Clearomiser 101
Make sure youare filling fromthe right end
(tip: you fill BDC’s fromthe bottom & standard
clearomisers fromthe top!)
E-liquid inmouth
Don’t take long drags
(especially if using a low ohm clearomiser)
Don’t hold thebutton down for
too long(tip: turn it off in
your bag or pocket)
Don’t allowthe e-liquid
to run too low
Allow at least5 minutes for
the e-liquid to soak in
(If it’s a new coil)
Clean the clearomiserby running
water through it(allow to dry for
12 hours)
Change thecoil
It may be timefor a new
clearomiser
Did it work?
Burnt Taste
No
Does a differentclearomiserwork on the
battery?(If not, then it may be
a battery fault)
Clean battery& clearomiserconnection
points
Ensure coil isscrewed securily tothe base
Not gettingenough vape
Ensure thebattery is fullycharged and
turned on
Check for cracks
Have you leftyour
clearomiser ina too hot or toocold a place?(If so, leave it in aplace with a cool
temperature)
Ensure the rubber seals
have not shiftedor broken
Ensure theconnections
have not cross-threaded
Leaking
Ensure you have not
flooded yourclearomiser
(Got any liquid downthe centre tube)
Give the clearomiser
a flick
Remove base& blow
through mouth piece
Gurgling
www.ecigarettedirect.co.uk/ashtray-blog
www.ecigarettedirect.co.uk
A useful guide from the Ashtray Blog
*
*
*
**
BDC (bottom dual coil) clearomisers are filled from the bottom and have a replaceable coilKey: All steps marked with a are for BDC clearomisers only.*
Yes
Having problems with your clearomiser?Use this handy flowchart to diagnose and resolve issues - and get back vaping without delay!