Detail no: SB01 - Nov 2013 · 2 days ago · Detail no: SB25 - Nov 2013 Floor Level Min. 200mm overlap to base of footing Minimum 6mm Coreflute board protection Compacted backfill

100 100

300 300

30

0

Plastic DPM

Compacted backfill

Min. 300mm overlap with Bentonite Paste in the lap

1.1 Metre wide piece of SikaProof Bentonite fully bonded to cast concrete

SikaProof Bentonite

Detail no: SB01 - Nov 2013

Scale 1:5

Plastic DPM overlap - Compacted

Backfill

SikaSwell P Profile 2010H

jktan

Stamp

100 100

300 300

30

0

Min. 300mm overlap with Bentonite Paste in the lap

Minimum 6mm Coreflute board protection

Granular free drainage backfill

100mm perforated drainage pipe wrapped in geotextile filter fabric

Plastic DPM

1.1 Metre wide piece of SikaProof Bentonite fully bonded to cast concrete

Plastic DPM overlap - Free Draining

Backfill

SikaProof Bentonite

Scale 1:5



jktan

Stamp

200mm

SikaSwellP Profile 2010H

SikaProof Bentonite patches

Compacted backfill

Fill void with Sika Grout 212

Minimum 50mm site concrete

Mortar pads

SECTION

SikaProof Bentonite

Allow 300mm overlap of SikaProof Bentonite to laponto under slab waterproof


SikaProof Bentonite preappliedin pre-cast yard


Scale 1:10

Precast Lift Pit Detail - Compacted

Backfill

jktan

Stamp


50mm Site concrete

50mm Site concrete

Compacted backfill

SECTION


Note:Laps in SikaProof Bentonite to be taken minimum300mm past corner angles and construction joints

40mm angle fillet of SikaProof Bentonite Paste

SikaProof Bentonite preapplied toinside face of outside shutterprior to concrete pour

SikaProof Bentonite

Scale 1:10


Typical Lift Pit - Cast In-situ

Compacted Backfill

jktan

Stamp

Compacted backfill


SikaProof Bentonite shot fired to wall using mechanicalfasteners or preapplied to inside face of outside shutter.

SikaProof Bentonite

Pre-cast - Compacted Backfill

Application to Walls

Scale 1:5

jktan

Stamp

Note:Blowholes and minor imperfections shall be bagged with Sika MonoTop Fairing Coat or other appropriate motar.Not required if pre-applied to shutter.




In-situ Wall - Free Draining Backfill


SikaProof Bentonite

Scale 1:5


jktan

Stamp

Compacted backfill

In-situ Wall - Compacted backfill



Note:Blowholes and minor imperfections shall be bagged with Sika MonoTop Fairing Coat or other appropriate motar.Not required if pre-applied to shutter.

SikaProof Bentonite

Scale 1:5


jktan

Stamp

100 100

10

0

100

Second layer of SikaProof Bentonite

Jubilee clip

Boxed Out Pipe Penetration

Free Draining Backfill

SikaProof Bentonite


SikaProof Bentonite



Sika Grout 212 finished flushwith surface

Scale 1:5

jktan

Stamp

100 100



SikaProof Bentonite


150mm Concrete haunchingaround pipe with tie to wall

Boxed Out Pipe Penetration


SikaProof Bentonite

Scale 1:5

jktan

Stamp

10

0

100

Second layer of SikaProof Bentonite

Jubilee clip



Cast In Pipe Penetration


SikaProof Bentonite


SikaProof Bentonite

Scale 1:5

jktan

Stamp

SikaProof Bentonite

150mm Concrete haunchingaround pipe with tie to wall



SikaProof Bentonite

Scale 1:5

Cast In Pipe Penetration

Compacted Backfill

jktan

Stamp

Concrete Walls - External Corner

- Post Fixed

SikaProof Bentonite shot fired to wall using mechanical fasteners or preapplied to inside face of outside shutter.

Note:Blowholes and minor imperfections shall be bagged with Sika MonoTop Fairing Coat or other appropriate motar.

External corner rounded off to6mm radius

SikaProof Bentonite


Scale 1:5

jktan

Stamp

SikaProof Bentonite

Concrete Walls - Internal Corner

- Post Fixed

40mm sand / cement cove


SikaProof Bentonite

Scale 1:5

jktan

Stamp

15

01

50


Pre-cast - Free Draining

Termination at Ground Level

4mm Sikalastic 152 taken 150mm above ground leveland lapped 150mm behind SikaProof Bentonite with40mm wide strip of SikaProof Bentonite Paste in the lap.

SikaProof Bentonite preapplied to formwork in pre-cast yard

Sikaflex 11 FC

SECTION

Ground level

25mmX2mm aluminium termination bar fixed @ maximum 300mm centres with mechanical fastener



SikaProof Bentonite

Scale 1:5

jktan

Stamp

200mm Square patch of SikaProof Bentoniteand bedded into paste and fastened into place


Concrete Walls - Tie Bolt Hole

Compacted or Free Draining Backfill

SikaProof Bentonite


SikaProof Bentonite

Scale 1:5

jktan

Stamp

15

01

50

Sikaflex 11 FC

4mm Sikalastic 152 taken 150mm above ground leveland lapped 150mm behind SikaProof Bentonite with40mm wide strip of SikaProof Bentonite Paste in the lap.


Blowholes and minor imperfections shall be bagged with Sika MonoTop Fairing Coat or other appropriate motar.


Pre-cast - Free Draining

Termination at Ground Level


SECTION


25mmX2mm aluminium termination bar fixed @ maximum 300mm centres with mechanical fastener

Ground level

SikaProof Bentonite

Scale 1:5

jktan

Stamp

Note:Blowholes and minor imperfections shall be bagged with Sika MonoTop Fairing Coat or other appropriate motar.

SikaProof Bentonite preapplied to formwork in pre-cast yard



Pre-cast - Free Draining Backfill


SikaProof Bentonite

Scale 1:5


jktan

Stamp

Water Proof to Pile Caps

Reinforced concrete

SikaSwell - P Profile Type 2010Hadhered with SikaSwell S-2 aroundprofile of pipe with 100mm cover

SikaProof Bentonite

40mm Fillet of SikaProof Bentonite Paste around profile of pile cap

Sikalastic 152 taken down sides of pile and below line of membrane

SikaProof Bentonite


Scale 1:5

jktan

Stamp

Scale 1:20


SikaProof Bentonite shot fired to wall using mechnical fasterners with washers. Waterproofing to secant piles shall be installed prior to the application of SikaProof Bentonite forunderslab waterproofing.

SikaProof Bentonite dressed around pile and taken 300mmout horizontal to piles to be cut and splayed to receiveunderslab application.

Apply a 40mm fillet of SikaProof Bentonite Pasteover SikaProof Bentonite along profile of the piles.

Secant Piles

Water Proof to Secant Piles - Step 1

SikaProof Bentonite

jktan

Stamp


Secant Piles

Cut SikaProof Bentonite to follow the profile of the piles

Waterproofing to underslab shall be installed afterthe application of the SikaProof Bentonite to the piles.

Place SikaProof Bentonite tight against secant piling.

Scale 1:20

Water Proof to Secant Piles - Step 2

SikaProof Bentonite

jktan

Stamp

30

0

Sheet piling

Reinforced concrete

SikaProof Bentonite

Step 3

Step 2

Step 1

SikaProof Bentonite shot fired to steel sheet pilingusing approved fixings and following the profile of the piles.

Apply a 40mm fillet of SikaProof BenronitePaste over 300mm cut and splayed SikaProof Bentonite along the profile of the piles

Cut SikaProof Bentonite to follow the profile of the piles

Place SikaProof Bentonite tightagainst sheet piling

Waterproofing to underslab shall be installed after the application of the SikaProof Bentonite

to the piles


Water Proof to Steel Sheet Piling

Not To Scale

SikaProof Bentonite

jktan

Stamp

Secondary overlap of SikaProof Bentonite with 60mm wide Bentonite Paste in lap

Self compacting concrete mix

SikaProof Bentonite pre-fixed to precast panel

SikaSwell - P Profile Type 2010Hadhered with SikaSwell S-2

Note:Blowholes and imperfections shall be bagged with Sika MonoTopFaining Coat or other appropriate cement based mortar


SikaProof Bentonite

Pre-cast Stitch Joint Detail

Easy Access

Scale 1:5

jktan

Stamp

PEF rod


100mm wide strip of SikaProof Bentonite

Sika Grout 212

Self compacting concrete with Sika Control 40

SikaProof Bentonite pre fixed at Pre-cast yard

SikaProof Bentonite

Pre-cast Stitch Joint Detail for

Limited Access Installation 1

Scale 1:5

jktan

Stamp

150 (N.T.S)

50 (

N.T

.S)

150 (N.T.S)


SikaProof Bentonite

Sika Grout 212 SikaProof Bentonite bonded in pre-cast beds to panel

SikaProof Bentonite pre-fixed to 6mm Hardiflex board taken 150mm past joint edge either side with 150mm SikaProof Bentonite Paste in both laps.

Pre-cast Stitch Joint Detail for

Limited Access Installation 2


Scale 1:5

jktan

Stamp

100 100

300

min

.

Pre-cast Panel / Footing Junction

Scale 1:5


Floor Level

Min. 200mm overlapto base of footing


Compacted backfill

SECTION

Note:

Timber boxing to rear of footing and

timber panel guide must be removed.SikaProof Bentonite preapplied in pre-cast yard


Sika Grout 212 fillet

SikaProof Bentonite

SikaProof Bentonite

jktan

Stamp

150 (N.T.S) 150 (N.T.S)

50 (

N.T

.S)

Sika Grout 212

SikaProof Bentonite bonded in pre-cast beds to panels

Pre-cast Panel sealant joint Detail

for Limited Access Installations

SikaProof Bentonite

SikaProof Bentonite pre-fixed to 6mm Hardiflex board taken 150mm past joint edge either side with 150mm SikaProof Bentonite Paste in both laps.

Scale 1:5

Sikaflex Sealant on PEF rod


jktan

Stamp

Documents

Detail no: SB01 - Nov 2013 · 2 days ago · Detail no: SB25 - Nov 2013 Floor Level Min. 200mm overlap to base of footing Minimum 6mm Coreflute board protection Compacted backfill