C2500 D5A50Diesel

Our energy working for you.™

1/4 1/2 3/4 Full 1/4 1/2 3/4 Full37.0 66.6 97.2 132.1 35.1 61.3 88.8 117.8140 252 368 500 133 232 336 446

» Generator set data sheet

Model:Frequency:Fuel Type:

2500 kVA Standby

©2007 Cummins Power Generation Inc. All rights reserved. Cummins Power Generation and Cummins are registered trademarks of Cummins Inc. “Our energy working for you.” is a trademark of Cummins Power Generation. APSB-1154-07 (9/07)

635145.2

176

Electronic24 Volts DC

1800 ±50146

Air

Fuel flow

602031515

Fuel consumption

9.5

Ratings

Stroke, mm Rated speed, rpm

LoadUS gphL/hr

Engine

Gross engine power output, kWm

Engine manufacturerEngine model

Piston speed, m/sCompression ratio

Configuration

BMEP at set rated load, kPa

Aspiration

Bore, mm

Lube oil capacity, L

Maximum fuel flow, L/hr

Governor typeStarting voltage

Maximum fuel inlet temperature (°C)Maximum fuel inlet restriction, mm Hg

Maximum air cleaner restriction, mm H2O156.2

Overspeed limit, rpmRegenerative power, kWm

CumminsPrime rating

159

QSK60G84-Cycle; 60° Vee; 16-Cylinder DieselTurbo Charged and Low Temperature Aftercooled

25752145 1942

14.5:1

1901500

PrimekW (kVA)1800 (2250)

StandbykW (kVA)2000 (2500)

Standby rating

Combustion air, m3/min

2848

Open Enclosed

Dimensions

Our energy working for you.TM

485

Weights*

344.1460

Prime rating

Unit wet weight kgsUnit dry weight kgs N.A.

N.A.

Maximum exhaust back pressure, mmHg

12.7

Exhaust gas flow at set rated load, m3/minExhaust gas temperature, °C

Ambient design, °C

Standard set-mounted radiator

Maximum cooling air flow static restriction mmH2O

621Coolant capacity (with radiator), LCooling system air flow, m3/min @ 12.7mmH2O

17000

Width "B"

* Weights represent a set with standard features. See outline drawing for weights of other configurations

Refer to factory

Enclosed set

Open set

Outlines are for illustrative purposes only. Please refer to the genset outline drawing for an exact representation of this model.

www.cumminspower.com

©2007 Cummins Power Generation Inc. All rights reserved. Cummins Power Generation and Cummins are registered trademarks of Cummins Inc. “Our energy working for you.” is a trademark of Cummins Power Generation. APSB-1154-07 (9/07)

Refer to factory Refer to factory

1860Total heat rejection, BTU/min 5610066000

Enclosed set standard dimensions, mm

Height "C"Length "A"

Standard open set dimensions, mm 280022705842

17720

33

Exhaust

40

Standby rating

Fan load, KWm

51

Genset outline

378.7

Feature code

-

B619B621

Notes:

Single phase output

kW x 1000Voltage

Our energy working for you.TM

125/80C

Connection1

Wye, 3 Phase

125/105Wye, 3 Phase

150/105C

1. Limited single phase capability is available from some three phase rated configurations. To obtain single phase rating, multiply the three phase kW rating by the single phase factor. All single phase ratings are at unity power factor.

Prime (unlimited running time):Applicable for supplying power to varying electrical load for unlimited hours. Prime Power is in accordance with ISO 8528. Ten percent overload capability is available in accordance with ISO 3046, AS 2789, DIN 6271 and BS 5514.

Base Load (Continuous): Applicable for supplying power continuously to a constant electrical load for unlimited hours. Continuous power in accordance with ISO 8528, ISO 3046, AS 2789, DIN 6271 and BS 5514.

3810/6600VS/P/C

P8

Temp rise degrees C

2. Standby (S) and Prime (P) ratings.

380-415VS/P

Duty2 VoltageAlternator

MVSI804R1S/P/C HVSI804S1

Ratings definitions

1905/3300V

Alternator data

www.cumminspower.com

©2007 Cummins Power Generation Inc. All rights reserved. Cummins Power Generation and Cummins are registered trademarks of Cummins Inc. “Our energy working for you.” is a trademark of Cummins Power Generation. APSB-1154-07 (9/07)

Wye, 3 Phase

Formulas for calculating full load currents:

Three phase output

Fax: (65) 6417 2399Tel: (65) 6417 2388

E-Mail: cpg.apmktg@cummins.com

kW x 1000Voltage x 1.732 x 0.8

TT International Tradepark10 Toh Guan Road #07-01

See your distributor for more information.

Asia Pacific Cummins Power Generation

Standby:Applicable for supplying power to varying electrical load for the duration of power interruption of a reliable utility source. Emergency Standby Power (ESP) is in accordance with ISO 8528. Fuel Stop power in accordance with ISO3046, AS 2789, DIN 6271 and BS 5514.

Limited Time Running:Applicable for supplying power to a constant electrical load for limited hours. Limited Time Running Power is in accordance with ISO 8528.