E3 FLASHER SLIM CONSOLE Installation Manual With Clip (1)

7/29/2019 E3 FLASHER SLIM CONSOLE Installation Manual With Clip (1)

1/22


2/22

2: take out nut on the HD, and get out hardisk .

3: Remove the seal, and take off all nuts.

4: open Top cover


3/22


4/22


5/22

8: Unplug the front buttom board before take out BD driver. Please note only

disconnect with console, no need take out, because there has cable link to

mainboard.

And then cable take out BD DRIVER.


6/22

9: Unplug antenna, and remove from mainboard track, no need disconnect metal of

antenna, and unplug the front board together with cable.


7/22

Finally disconnect picture

10: You need take off four white nuts before take out mainboard.(white nut is fixed

for HD)


8/22


9/22


10/22

SLIM console CLIP installation tutorial:

1: First you need install CLIP as following picture showes :

Please check the direction and position if correct. E3 slim clip is designed precisely, to

install on mainboard seamless. Please check following picture, if install correctly,

there is very thin seam between CLIP and mainboard, and they are same level. Any

Diffirence flat means wrong installation.


11/22


12/22

Attention : dont bend softboard 180horizontal, this way will destroy softboard.

The softboard need keep natural curve .

Completed


13/22


14/22


15/22


16/22

At last install buttom board on mainboard

3: Install power moduel, please install the two nut well and then install power cable


17/22


18/22


19/22

And then ducked the connector on soft board into mainboard socket, you can press

from left to right with finger. You will hear clear sound from connector if you connect

correctly.


20/22

Install correctly

Push mainboard into HD warehouse, becareful otherwise it will damage connector of

SATA , or not connect corretly.

Then, install E3 FLASHER cover board into mainboard, dont mistake the location.


21/22


22/22

Finally, connect ESATA station, put original PS3 HD into esata station and setting

buttom on COVER BOARD to PS3 MODE, OFW.

the HD switching sequence is :

turn off PS3turn off esata station powerunplug PS3 power cableplace HD to

esata stationplug ESATA cable to ps3 plug PS3 power cablepower on esata

stationturn on ps3. If can turn on ps3 correctly, congratulate you are successful !

PS: to assure you install e3 flasher correctly, it s better you test e3 flasher before

remount console.

Documents

E3 FLASHER SLIM CONSOLE Installation Manual With Clip (1)