The Alfa Casteel Hanger 90˚/90˚ is an interior formwork suspension device. It is robust and designed primarily for use on beams, which are of steel or concrete. The Casteel 90˚/90˚ can be used with coil rods Alfa A-12 1/2" or 3/4". It can be used with all types of beams because the ADJUST-MENT is done with the rod. Stan-dard lengths of 12", 16" and 24" are available. Other lengths avai-lable on request.

ALFA CASTEEL HANGER 90°/90°

ALFA ENGINEERED CONCRETE PRODUCTS | Tel.: 514-705-1520 | stevenunsworth1@icloud.com | www.alfacoffrage.com

CASTEEL HANGER 90° / 90°SELECTION CHART

Product CodeRod Diameter

(A)Spacing

(B)Safe Working Load (SWL)

CS-50-90/90x300 1/2" 12" (304.8mm) 6,500 lbs

CS-50-90/90x400 1/2" 16" (406.4mm) 6,500 lbs

CS-50-90/90x600 1/2" 24" (609.6mm) 6,500 lbs

CS-75-90/90x300 3/4" 12" (304.8mm) 12,000 lbs

CS-75-90/90x400 3/4" 16" (406.4mm) 12,000 lbs

CS-75-90/90x600 3/4" 24" (609.6mm) 12,000 lbs

SWL : Safe working load based on an approximated safety factor of 2:1

Warning: (1) Do not exceed the safe working load of this product. (2) The Casteel must have support under each end of his suspension. (3) The contractor must properly determine the width (fl ange) of the beam before ordering Casteel hanger.

ALFA CASTEEL HANGER 90°/90°

TO ORDER:Specify quantity, product code, rod diameter and spa-cing.