Upload
marlon-adams
View
533
Download
114
Tags:
Embed Size (px)
DESCRIPTION
Huawei Genex Probe user guide
Citation preview
Connecting UE to laptop Plug UE to USB port -> Drivers will attempt to install automatically (if not successful); Go to Computer -> Select UE drive -> run ‘hwpcassistant’ -> install driver software
UE should be able to connect after driver installed. to confirm; Go to device manager -> view Ports (COM & LPT) -> once the UE connects successfully
the Laptop will assign a COM port
Starting Probe
Prior to starting Probe software, Huawei Engineer will provide installation software/license. Open
The software will prompt you to update license; follow instruction and update accordingly
After license update successfully, the Probe software will now be usable.
Creating a New Project
Project -> New -> Select template type based on Network
Saving a Project Project -> New -> Select template type based on Network
Configuration -> Device Management -> Device Configure
Configuring Test devices
Device configuration window will be displayed:
Configuring Test Devices
Adding UE to Probe: Select MS -> Select add device the device configuration dialog box will appear.
Confirm COM port -> Select UE Model -> Modem Port will be assigned automatically -> Select OK.
Device configuration window will be displayed:
Configuring Test Devices
Adding GPS to Probe: Select GPS -> Select add device the device configuration dialog box will appear.
Confirm COM port -> Select GPS Model (NMEA)-> Modem Port will be assigned automatically -> Select OK.
Test Plan will be created by Huawei Engineer (Configuration -> Test Plan Control -> The TEST Plan Control dialog window will appear.
Configuring Test Plan
Each UE can be configured with a defined function controlled by Test Plan. These Test Plan will be provided by Huawei and upload to UE according to drive test requirement. UE 1 – Short Call UE2 – Long Call UE3 – Data UE4 – Idle (No test plan required)
Select folder highlighted RED -> Navigate to Map director -> select map (.tab file) -> Open
Configuring OutdoorMap
Configuration -> Engineering Parameter Management -> Dialog box will appear.
Loading Engineering Parameter Table
Select folder -> Select System -> Navigate to directory with EPT is located and Select correct EPT -> Select Next
Select folder -> Select System -> Navigate to directory with EPT is located and Select correct EPT (.xls).
After EPT has been imported successfully -> Select the “apply” option. (The Engineering Parameter Management window can be closed after this step)
Loading Engineering Parameter Table Outdoor Map window displaying vector map and
sites (from EPT imported)
Go to control -> Click Start Test Plan -> a dialog box will appear asking to start recording -> select yes and save to specified folder.
Starting Test Plan/Recording Probe_20150713170045 (default log name:
date/time)