Embed Size (px)
Citation preview
Instruction Manual
○
o
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
○
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
○
○
o
o
o o o o
○
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
○
o
o
o
o
o
o
○
○
○
o
o
○
○
○
○
○
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
○
○
o
o
o
o
o
o
○
○
○
○
○
PUSH-PULL SYSTEM
○
○
○
○
○
○
○ Install the ball linkage to the servo arm and control horn as done with the previous linkage
connections. Use a 2.5mm hex driver and 5.5mm nut driver to secure the hardware in place.
○ With the radio powered on, make any final adjustments to the linkage length to center the rudder
accordingly.
o
o
o
o
o
o
○
○
○
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
○
o
o
o
o
o
o
○
o
o
o
o
o
o
o
○
○
○
○
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
○
○
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
o
o
o
o
o
o
o
o
o
o
o
o
o o
○
○
○
○
○
o
o
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
○
○
○
o
o
o
o
o
o
○
○
○ T
○ After the tank is in position, route and trim your fuel lines appropriately.
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
o
o
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
o
o
o
o
o
o
o
o
o
o
o
o
○
○
○
○
○
○
○ 1.
○ 2.
○ 3.
○ 4.
○ 5.
○ 6.
○ 7.
www.flexinnovations.com © 2020 Flex Innovations, LLC. Potenza™ is a trademark or registered trademark of Flex Innovations, LLC.
![TOPN Messages - Cisco · %TR-2-PANICINF: Unit [dec], PI [hex] [hex] [hex] [hex] [hex] [hex] Explanation This message is similar to the (Jeanine check source.) Recommended Action Copy](https://img.pdfslide.net/doc/110x75/5f96ea0c176ab92a087a6e14/topn-messages-cisco-tr-2-panicinf-unit-dec-pi-hex-hex-hex-hex-hex.jpg)
