-
AllSportSystems, Inc.© 2020.
Setup Guide
Click here to view our video setup guide.
Page 1 of 11
https://youtu.be/2mdBrtSpu_g
-
AllSportSystems, Inc.© 2020.
Required Tools: ● Drill with 5/16” drill bit ● 6mm Hex or Allen
Wrench ● Flight Yoke - Hex or Allen Wrench
○ 2.5mm - Honeycomb Yoke ○ 3.0mm - Logitech Yoke
● Throttle Quadrant - 7/64” Hex or Allen Wrench ● Tape
measure
Page 2 of 11
-
AllSportSystems, Inc.© 2020.
Step 1. Remove the following 4 screws from the top of your
flight yoke.
Honeycomb Logitech / Saitek
Page 3 of 11
-
AllSportSystems, Inc.© 2020.
Step 2. Align the mounting bracket with the screw holes in the
top of your flight
yoke and screw the yoke to the mounting bracket using the 4
screws you removed from the previous step.
Page 4 of 11
-
AllSportSystems, Inc.© 2020.
Step 3. Drop the 4 included 6-32 screws through the
corresponding 4 holes on the right side of the mounting
bracket.
Page 5 of 11
-
AllSportSystems, Inc.© 2020.
Step 4. Attach the throttle quadrant to the mounting bracket
using the 4 included
washers and nuts. The 4 screws inserted in the previous step
will go through holes in the top of the throttle quadrant desk
mount. Use the 7/64” hex or allen wrench to fully secure the
throttle to the mounting bracket.
Page 6 of 11
-
AllSportSystems, Inc.© 2020. Step 5.
Drilling the mounting holes into your desk:
Page 7 of 11
-
AllSportSystems, Inc.© 2020.
Step 6. Use a 6mm hex or allen wrench to install the 3 included
threaded wood
inserts. Be sure to not over tighten the threaded wood inserts
into the drilled holes, as this could strip out the inside of the
drilled hole making it unusable.
Page 8 of 11
-
AllSportSystems, Inc.© 2020. Step 7.
Screw the 3 included knobs into the threaded wood inserts that
were installed in the previous step. Only screw them in partially,
leaving about ½” of the screw thread exposed.
Page 9 of 11
-
AllSportSystems, Inc.© 2020. Step 8.
Slide your mounting bracket (with yoke and throttle quadrant
already mounted) onto the 3 knobs. Tighten down the 3 knobs to
secure your yoke and throttle quadrant to the desk.
Page 10 of 11
-
AllSportSystems, Inc.© 2020.
You’re now ready for flight!
To remove the bracket from your desk, simply loosen the 3 knobs
holding it in place and slide it away.
Happy flying!
Page 11 of 11
