Instruction Manual for Bee-Ball Netball Stand 88101

WARNING: IMPROPER

INSTALLATION OR SWINGING

ON THE RING MAY CAUSE

SERIOUS INJURY OR DEATH

Struts # 3

Net #4

Wheel Axle #5 Wheel #6

Rim #2

Base #1

Top Pole

#7

Adjustment

Pole #8

Middle

Pole #9

Bottom

Pole #10

1 x 50mm

Bolt #A

2 x 45mm

Bolt #B

2 x 20mm

Bolt #C

4 x 16mm

Bolt #D

Hand Screw

# E

Overview, please see following pages for step by step instructions.

Tools Required:

Spanner Set Socket set

Tip

Please see advice below for correct nut and bolt assembly.

Assembly Instructions:

Step 1. Begin by putting the wheel axel (#5) through the base (#1) and the bottom pole

(#10) and wheels (#6).

Step 2.

Now fix the support struts (#3) into the base and on to the bottom pole. Use the M8*20cm

screws to attach struts to base.

Step 3.

Now attach the uprights to the bottom pole using the M8*50mm bolt to fix into the pole.

Step 4.

Assemble the next two upright poles as shown below using the M8*45mm bolts, the top

pole is attached using the M8*20mm hand screw.

Tip. For the next step you might find it easier to lay the Netball Stand, it is always

recommended to make sure the stand is secure to avoid injury.

Step 5.

Fix the rim to the plate on the top pole using the 4 x M6*16cm bolts. At this stage it is best

to attach the net too.

*Please note – Height of stand can be adjusted by turning the adjustment screw on the

second from top pole and sliding the top pole up or down. Height can also be adjusted by

removing one pole section.

Attaching the Net: Step 6: Fit the net from the outside in, loop the net over the hook and then pull.

Installation and Care Instructions

• If using a ladder during assembly, use extreme caution.

• Climate, corrosion or misuse could result in system failure.

• Minimum operational height is 6'6" (1.98m) to the bottom of the backboard.

Safety Instructions

• Owner must ensure that all players know and follow the rules for safe operation of the

system.

• Do not hang on the rim or any part of the system including the backboard, rim, support

braces or net.

• During play, especially when performing dunk type activities, keep players face away from

the backboard, rim and net. Serious injury could occur if teeth/face come in contact with the

backboard, rim or net.

• During play do not wear jewellery (rings, watches, necklaces etc) Objects may entangle in

the net.

• Check the system before each use for loose hardware, excessive wear and signs of corrosion

and repair before use.

• Never play on damaged equipment.

Big Game Hunters,

Holly House, Pinewoods Road, Longworth, Oxon,

OX13 5HG

Tel: 01865 392439

e: sales@biggamehunters.co.uk

w: www.biggamehunters.co.uk

tw: @thePlayExperts

We like to ensure our products are quick and easy to assemble so you can start enjoying your

purchase as soon as possible. If you have any recommendations on how the assembly instructions

could be improved, please let us know. We greatly value your opinion; please email all

recommendations to instructions@biggamehunters.co.uk for us to review.