Upload
vincent-dalton
View
215
Download
0
Embed Size (px)
Citation preview
Introduction
In previous lessons, we have found the slope of linear
equations and functions using the slope formula, .
We have also identified the slope of a line from a given
equation by rewriting the equation in slope-intercept
form, y = mx + b, where m is the slope of the line. By
calculating the slope, we are able to determine the rate
of change, or the ratio that describes how much one
quantity changes with respect to the change in another
quantity of the function. 1
3.3.2: Proving Average Rate of Change
Introduction, continuedThe rate of change can be determined from graphs, tables, and equations themselves. In this lesson, we will extend our understanding of the slope of linear functions to that of intervals of exponential functions.
2
3.3.2: Proving Average Rate of Change
Key Concepts• The rate of change is a ratio describing how one
quantity changes as another quantity changes.
• Slope can be used to describe the rate of change.
• The slope of a line is the ratio of the change in y-values to the change in x-values.
• A positive rate of change expresses an increase over time.
• A negative rate of change expresses a decrease over time.
3
3.3.2: Proving Average Rate of Change
Key Concepts, continued• Linear functions have a constant rate of change,
meaning values increase or decrease at the same rate over a period of time.
• Not all functions change at a constant rate.
• The rate of change of an interval, or a continuous portion of a function, can be calculated.
• The rate of change of an interval is the average rate of change for that period.
4
3.3.2: Proving Average Rate of Change
Key Concepts, continued• Intervals can be noted using the format [a, b], where a
represents the initial x value of the interval and b represents the final x value of the interval. Another way to state the interval is a ≤ x ≤ b.
• A function or interval with a rate of change of 0 indicates that the line is horizontal.
• Vertical lines have an undefined slope. An undefined slope is not the same as a slope of 0. This occurs when the denominator of the ratio is 0.
5
3.3.2: Proving Average Rate of Change
Key Concepts, continued
• The rate of change between any two points of a linear function will be equal.
6
3.3.2: Proving Average Rate of Change
Calculating Rate of Change from a Table1. Choose two points from the table.
2. Assign one point to be (x1, y1) and the other point to be (x2, y2).
3. Substitute the values into the slope formula.
4. The result is the rate of change for the interval between the two points chosen.
Key Concepts, continued• The rate of change between any two points of any
other function will not be equal, but will be an average for that interval.
7
3.3.2: Proving Average Rate of Change
Calculating Rate of Change from an Equation of a Linear Function1. Transform the given linear function into slope-
intercept form, f(x) = mx + b.
2. Identify the slope of the line as m from the equation.
3. The slope of the linear function is the rate of change for that function.
Key Concepts, continued
8
3.3.2: Proving Average Rate of Change
Calculating Rate of Change of an Interval from an Equation of an Exponential Function1. Determine the interval to be observed. 2. Determine (x1, y1) by identifying the starting x-value
of the interval and substituting it into the function. 3. Solve for y.4. Determine (x2, y2) by identifying the ending x-value of
the interval and substituting it into the function. 5. Solve for y. 6. Substitute (x1, y1) and (x2, y2) into the slope formula
to calculate the rate of change.7. The result is the rate of change for the interval
between the two points identified.
Common Errors/Misconceptions• incorrectly choosing the values of the indicated
interval to calculate the rate of change
• substituting incorrect values into the formula for calculating the rate of change
• assuming the rate of change must remain constant over a period of time regardless of the function
• interpreting interval notation as coordinates
9
3.3.2: Proving Average Rate of Change
Guided Practice
Example 2In 2008, about 66 million U.S. households had both landline phones and cell phones. This number decreased by an average of 5 million households per year. Use the table to the right to calculate the rate of change for the interval [2008, 2011].
10
3.3.2: Proving Average Rate of Change
Year (x)Households in millions (f(x))
2008 66
2009 61
2010 56
2011 51
Guided Practice: Example 2, continued
1. Determine the interval to be observed. The interval to be observed is [2008, 2011], or where 2008 ≤ x ≤ 2011.
11
3.3.2: Proving Average Rate of Change
Guided Practice: Example 2, continued
2. Determine (x1, y1).The initial x-value is 2008 and the corresponding y-value is 66; therefore, (x1, y1) is (2008, 66).
12
3.3.2: Proving Average Rate of Change
Guided Practice: Example 2, continued
3. Determine (x2, y2).The ending x-value is 2011 and the corresponding y-value is 51; therefore, (x2, y2) is (2011, 51).
13
3.3.2: Proving Average Rate of Change
Guided Practice: Example 2, continued
4. Substitute (x1, y1) and (x2, y2) into the slope formula to calculate the rate of change.
Slope formula
Substitute (2008, 66) and (2011, 51)
for (x1, y1) and (x2, y2).
Simplify as needed.
= –514
3.3.2: Proving Average Rate of Change
Guided Practice: Example 2, continuedThe rate of change for the interval [2008, 2011] is 5 million households per year.
15
3.3.2: Proving Average Rate of Change
✔
16
3.3.2: Proving Average Rate of Change
Guided Practice: Example 2, continued
16
Guided Practice
Example 3A type of bacteria doubles every 36 hours. A Petri dish starts out with 12 of these bacteria. Use the table to the right to calculate the rate of change for the interval [2, 5].
17
3.3.2: Proving Average Rate of Change
Days (x)Amount of
bacteria (f(x))0 12
1 19
2 30
3 48
4 76
5 121
6 192
Guided Practice: Example 3, continued
1. Determine the interval to be observed. The interval to be observed is [2, 5], or where 2 ≤ x ≤ 5.
18
3.3.2: Proving Average Rate of Change
Guided Practice: Example 3, continued
2. Determine (x1, y1).The initial x-value is 2 and the corresponding y-value is 30; therefore, (x1, y1) is (2, 30).
19
3.3.2: Proving Average Rate of Change
Guided Practice: Example 3, continued
3. Determine (x2, y2).The ending x-value is 5 and the corresponding y-value is 121; therefore, (x2, y2) is (5, 121).
20
3.3.2: Proving Average Rate of Change
Guided Practice: Example 3, continued
4. Substitute (x1, y1) and (x2, y2) into the slope formula to calculate the rate of change.
Slope formula
Substitute (2, 30) and (5, 121)
for (x1, y1) and (x2, y2).
Simplify as needed.21
3.3.2: Proving Average Rate of Change
Guided Practice: Example 3, continuedThe rate of change for the interval [2, 5] is approximately 30.3 bacteria per day.
22
3.3.2: Proving Average Rate of Change
✔
23
3.3.2: Proving Average Rate of Change
Guided Practice: Example 3, continued