2011/7/4 1

IEC/EN 61347-2-13

LED Driver IEC/EN 61347-2-13 的驗證要求說明LED Driver IEC/EN 61347-2-13 的驗證要求說明

.

2011/7/4 2

IEC/EN 61347-2-13

本課程主要內容

IEC/EN 61347 標準介紹

名詞定義

標示

零件要求

結構要求

測試項目

2011/7/4 3

IEC/EN 61347-2-13

IEC/EN 61347 系列標準介紹

一般要求: IEC 61347-1:2007, EN 61347-1:2008Lamp controlgear-Part 1: General and safety requirements

常用的 Part 2 個別要求 (Particular requirements)

IEC/EN 61347-2-1: for starting devices other than glow starter (Ignitor, Electronic starter) --- 點火器

IEC/EN 61347-2-2: for d.c. or a.c. supplied electronic step-down convertors forfilament lamps) --- 電子式變壓器

IEC/EN 61347-2-3: for a.c. supplied electronic ballasts for fluorescent lamps --- 電子式安定器

2011/7/4 4

IEC/EN 61347-2-13

常用的 Part 2 個別要求 (Particular requirements)

IEC/EN 61347-2-8: for ballast for fluorescent lamps (Winding type ballast) --- 線圈式安定器

IEC/EN 61347-2-9: Particular requirements for ballast for discharge lamp excluding fluorescent lamps (Winding type ballast) --- HID 安定器

IEC/EN 61347-2-10: for electronic invertors and convertor for high-frequencyoperation

IEC/EN 61347-2-11: for miscellaneous electronic circuits used with luminaires

IEC/EN 61347-2-12: for Electronic ballast for discharge lamp (HID Ballast) --- HID 電子式安定器

IEC/EN 61347-2-13: for d.c. or a.c. supplied electronic controlgear for LED modules --- 照明用LED 電源供應器

2011/7/4 5

IEC/EN 61347-2-13

IEC 61347-1: 2007EN 61347-1: 2008Lamp controlgear-General and safety requirements

IEC 61347-2-13: 2006EN 61347-2-13: 2006Particular requirements for d.c. or a.c. suppliedelectronic controlgear for LED modules

2011/7/4 6

IEC/EN 61347-2-13

IEC/EN 61347-2-13 的應用範圍

電源輸入:

≤ 250 Vdc 或≤ 1000 Vac, 50Hz or 60Hz

輸出電壓:

SELVSELV equivalent (等效SELV)Higher voltages

2011/7/4 7

IEC/EN 61347-2-13

名詞定義

2011/7/4 8

IEC/EN 61347-2-13

名詞定義

2011/7/4 9

IEC/EN 61347-2-13

Built in controlgear ?(內置於燈具, 線盒, 外殼內)

Independent SELV controlgear ?(可裝置於燈具外無須額外之外殼, 且具有其標示所示之保護功能)

Additional compliance of Annex I

符合 IEC 60598-1 相關要求

2011/7/4 10

IEC/EN 61347-2-13

Built in type or Independent type ?

2011/7/4 11

IEC/EN 61347-2-13

Marking:

必須標示

依產品狀況而定

50/60Hz

2011/7/4 12

IEC/EN 61347-2-13

Marking:

其它標示要求如下:

可更換零件的清楚說明

接地符號

定電壓輸出形式的產品: 額定輸出電壓 (V)

定電流輸出形式的產品: 額定輸出電流 (A), 額定最大輸出電壓 (V)

The controlgear is suitable for operation with LED modules only.

(只供 LED 模組使用)

2011/7/4 13

IEC/EN 61347-2-13

Marking or manufacturer’s catalogue or similar:

2011/7/4 14

IEC/EN 61347-2-13

2011/7/4 15

IEC/EN 61347-2-13

Fail-safe controlgear不正確使用下功能失效,無危險性

Non-short-circuit proof controlgear 無短路保護

Short-circuit proof controlgear具短路保護

Inherently short-circuit proof controlgear 保護元件失效下, 過載或短路時溫度不會超過限制值,過載或短路移除後產品可恢復正常運作

Non-inherently short-citcuitproof controlgear 過載或短路時,保護元件動作

2011/7/4 16

IEC/EN 61347-2-13

必須符合 DIN VDE 0710-14

組裝說明書或使用手冊, 必須標示產品使用時的周圍環境,

範例圖示如下:

? mm

? mm

? mm ? mm

2011/7/4 17

IEC/EN 61347-2-13

不正常運作下, 外殼最高溫度 ≤ 130°C

不正常運作下, 外殼最高溫度 ≤ 110°C

正常運作下, 外殼最高溫度 ≤ 95°C

不正常運作下, 外殼最高溫度 ≤ 115°C

tc 正常運作下, 外殼最高溫度 ≤ tc°C

2011/7/4 18

IEC/EN 61347-2-13

Components:

重要零件需提供歐規TUV或VDE(IEC/EN)證書

電流保險絲必須為歐規認可品

Independent controlgear 的電源線絕緣材質必須為歐規認可品, 且電源

線線徑必須至少 0.75 mm2

若產品定義防水防塵 (IP code) (IPX1 or higher),

則 independent controlgear 的電源線絕緣材質必須是橡膠

(rubber, H05RN-F), 且線徑必須至少 1.0 mm2

2011/7/4 19

IEC/EN 61347-2-13

Construction: Built in SELV controlgear:

Primary Secondary

Earth

L

N

Cl. 1.7mmCr. 2.5mm

B: Cl. 2.0mmB: Cr. 2.5mm

R: Cl. 4.0mmR: Cr. 5.0mm

R: Reinforced insulation

B: Basic insulation

Between fuse terminations: Cr. 2.5mm, Cl. 1.7mm

變壓器絕緣距離 依工作電壓查表 (IEC60065, Tables 8-11)

Supposed Input 250Vac

?

2011/7/4 20

IEC/EN 61347-2-13

Construction: Independent SELV controlgear:

Primary Secondary

Earth

L

N

Cl. 3.0mmCr. 3.0mm

B: Cl. 3.0mmB: Cr. 3.0mm

R: Cl. 6.0mmR: Cr. 6.0mm

R: Reinforced insulation

B: Basic insulation

S: Supplementary insulation

S: Cl./ Cr. 依工作電壓查表

Between fuse terminations: Cr. 3.0mm, Cl. 3.0mm

變壓器絕緣距離 依工作電壓查表 (IEC 61347-2-13, Table I.7)

Earthed enclosure

Supposed Input 250Vac

no connection

2011/7/4 21

IEC/EN 61347-2-13

Construction: Independent SELV controlgear:

Primary Secondary

R: Reinforced insulation

Plastic Enclosure

R: Cl. 6.0mmR: Cr. 6.0mm

R: Cl. 6.0mmR: Cr. 6.0mm

R: Cl./ Cr. 依工作電壓查表

Supposed Input 250Vac

user accessible part

2011/7/4 22

IEC/EN 61347-2-13

Construction: Independent SELV controlgear:

Distance through insulation (R) - three layers of thin sheet insulation: 0.3mm (output > 100VA)

0.2mm (output: 25VA ∼ 100VA) 0.1mm (output: < 25VA)

S

P

P

2011/7/4 23

IEC/EN 61347-2-13

Construction: Independent SELV controlgear:

Distance through insulation (R): 1.0mmInput terminals output terminals: ≥ 25 mm

2011/7/4 24

IEC/EN 61347-2-13

Construction: Screw Terminal clause 14 of IEC 60598-1

‧線材的線徑必須能完全插入terminal,且必須完全被夾住

‧線材在螺絲鎖完後不能鬆落

‧線材線徑大小必須符合規範要求

常見的 screw terminal

2011/7/4 25

IEC/EN 61347-2-13

Construction: Screwless Terminal clause 15 of IEC 60598-1

常見的 screwless terminal

2011/7/4 26

IEC/EN 61347-2-13

Test Items: - Discharge test (1 min., ≤ 50V)- Protection of contact with live part: 10N force- Output exposed terminals test (for SELV-or SELV

equivalent controlgear)< 25 Vrms under load < 33 Vrms or 33√2 Vpeak under no-load

- Grounding test25A/1min. < 0.5 Ω

- Humidity test 91-95%, 20-30°C, 48h

2011/7/4 27

IEC/EN 61347-2-13

Test Items: - Insulation resistance test (immediately after humidity)

500V, 1min. B: > 2MΩ, D/R: > 4MΩ- Electric strength test Output circuit metal enclosure ?

2011/7/4 28

IEC/EN 61347-2-13

Supplementary information:

2011/7/4 29

IEC/EN 61347-2-13

Test Items: Transformer Heating test

Normal operation: comply IEC 60065 Table 3Abnormal operation: comply IEC 60065 Table 3

2011/7/4 30

IEC/EN 61347-2-13

Test Items: Heating test

Enclosure for testing: Annex F

Annex D

Note: Temp. shall be measured under ta.

2011/7/4 31

IEC/EN 61347-2-13

Test Items: - Fault condition test (component failure)

(temp. shall be measured under enclosure temp. tc)- Abnormal test (test for 1 hour)

I/P: -10%/+10% of supply voltageLength of cable for testing: 20cm and 200cmFor constant voltage output type* No LED module inserted* Double the LED module load (two LEDs connected in parallel)* Output shorted (multiple output, each output short-circuite in turn)

(temp. shall be measured under enclosure temp. tc)

2011/7/4 32

IEC/EN 61347-2-13

Test Items: - For constant current output type

* No LED module inserted* Double the LED module load (two LEDs connected in series)* Output shorted

(multiple output, each output short-circuite in turn)

(temp. shall be measured under enclosure temp. tc)

2011/7/4 33

IEC/EN 61347-2-13

Test Items: - Power cord pull test:

60N, 0.15Nm displacement < 2.0mm

- Torque test for screw terminal 測試次數: 5 次測試力距: 依照 IEC 60598-1 Table 14.4 或 Figures 12-16 中適用螺絲的力距, 以較大的力距測試

2011/7/4 34

IEC/EN 61347-2-13

Test Items: - Live part measurement

I/P: rated voltage* Measured according to IEC60990 circuit (measured point: part concerned earth)

* non-inductive resistance 50kΩ, >34Vpeak is live part (measured point: part concerned accessible part)

U2/500 mA

Note: one pole of the test supply shall be at earth potential.

2011/7/4 35

IEC/EN 61347-2-13

Test Items: - Ball pressure test

* 125°C for parts retaining live parts in position* 75°C for other parts providing protection against

electric shock

- Glow-wire test650°C, 30s for external parts of insulating material

- Needle-frame test10s for insulating material retaining live parts in position

2011/7/4 36

IEC/EN 61347-2-13

Supplementary information:

2011/7/4 37

IEC/EN 61347-2-13

Test Items: For Independent SELV controlgear- Heating test (comply Table I.1)

2011/7/4 38

IEC/EN 61347-2-13

Test Items: For Independent SELV controlgear- Short-circuit and overload protection (comply Table I.3)

2011/7/4 39

IEC/EN 61347-2-13

Test Items: For Independent SELV controlgear- Insulation resistance test (according to Table I.5)

2011/7/4 40

IEC/EN 61347-2-13

Test Items: For Independent SELV controlgear- Electric strength test (according to Table I.6)

2011/7/4 41

IEC/EN 61347-2-13

判定標準: 外殼不可破裂, 導致無法符合

EN 60598其他章節之求. (例如: 帶電體可被測試手指碰觸, 防水防塵等級無法

維持等)

Test Items: For Independent SELV controlgear- Mechanical strength test (EN 60598-1 Table 4.3)

2011/7/4 42

IEC/EN 61347-2-13

Questions ?