P L A N S B Y A N A W H I T E

TOTA L D I M E N S I O N S : 3 6 X 2 4 X 4 8 D I F F I C U LT Y L E V E L : I N T E R M E D I AT E

MITER SAW CART

P L A N S B Y A N A W H I T E

(1) 48”x96” 3/4” plywood

(1) 48”x48” 1/4” plywood

(4) Locking caster wheels (minimum 2-1/2” tall)

(40) 1-1/4” coarse thread pocket hole screws

(50) 18 gauge brad nails

(1) Wood glue

Table saw or circular saw

Drill/driver

18 Gauge brad nailer

Pocket hole tool

Pocket hole drill bit

LUMBER CUT LIST:

48” X 24” 48” X 24”

*HEIGHT OF CASTER WHEELS MUST BE AT LEAST 2-1/2” TALL

MATERIALS LIST:

PA G E : 2

RECOMMENDED TOOLS:

3/4” PLYWOOD

34-1/2” (MINUS HEIGHT OF CASTER*)

X 24” 3/4” SHEET

34-1/2” (MINUS HEIGHT OF CASTER*)

X 24” 3/4” SHEET

34-1/2” (MINUS HEIGHT OF CASTER*)

X 24” 3/4” SHEET

P L A N S B Y A N A W H I T E

LUMBER CUT LIST:

48” X 36” (MINUS HEIGHT OF CASTER*)

SCRAP

24” X 22-7/8” 24” X 22-7/8”

SCRAP

PA G E : 3

*HEIGHT OF CASTER WHEELS MUST BE AT LEAST 2-1/2” TALL

3/4” PLYWOOD

1/4” PLYWOOD

P L A N S B Y A N A W H I T E

ASSEMBLY:

Measure height of caster wheels and height of the miter saw deck. Subtract these measurements from 34-1/2”. From the 24” wide strips, cut three pieces to this length.

1

2

Rip 3/4” plywood into strips 24” wide by 8 feet long using either a table saw or circular saw.

Cut remaining pieces according to cut list.

3

HELPFUL HINTThe Home Depot stores will make complimentary plywood cuts.

PA G E : 4

P L A N S B Y A N A W H I T E

ASSEMBLY:

HELPFUL HINT

When attaching divider, use the shelves as a guide to place the divider.

Mark center of top/bottom. Attach divider to top and bottom with 1-1/4” pocket hole screws.

4 5Drill four 3/4” pocket holes on each end (measuring 24” long) of the side/divider pieces. Attach sides to top and bottom with 1-1/4” pocket hole screws.

PA G E : 5

P L A N S B Y A N A W H I T E

ASSEMBLY:

6Drill four 3/4” pocket holes on each end (measuring 24” long) of the shelves. Attach between divider and sides.

HELPFUL HINTSet shelf heights custom for your storage needs.

PA G E : 6

Apply Glue

P L A N S B Y A N A W H I T E

ASSEMBLY:

PA G E : 7

7Apply glue to back edges of the cart. Attach back with 3/4” brad nails.

HELPFUL HINTWe used a total of 50 brad nails to ensure a strong fit to glued back.

8 Install caster wheels at base of cart.