Upload
others
View
7
Download
0
Embed Size (px)
Citation preview
Aeronautical and Maritime Radiocommunication Systems
40300070 V2.0
MW 100 W NDB’’OFF-SHORE’’
INSTALLATION’
RBT9300P
�� OVERVIEW
This sheet is available on the site www.telerad.fr
NDB | LOCATOR
The radiobeacon RBT9300P is designed to equip ’’off-shore’’ platforms. Associated with the ’’Daisy’’ antenna, the transmitting range of this radiobeacon is around 200 km (over sea propagation).
This radiobeacon constitutes a dual transmission unit in the 200-535 kHz range (190-700 kHz on request).
We developped the study of this radiobeacon in order to hit the following targets :
� high performances and utmost reliability, � fast and simple installation and easy setting into service, � easy maintenance.
The addition of a TCL9300 IP link telemonitoring allows to monitor and to remote control the NDB.
�� INSTALLATION
Installation in a radio room :Rack of 42 U, designed to accomodate the following :
� two transmitters EBT9300P, adjustable up to 100W NON/A1A - NON A2A
� one automatic switching unit BRB9300P, compliant with I.C.A.O. requirements
� one ON/OFF control AMD9300P � one AC/DC rectifier
3 Antenna devices:On support or on bracket arm:
� Automatic tuning unit UAA9400IP, in a waterproof cabinet � “Daisy” antenna DASP100NM
Around the Helideck: � Automatic tuning unit DAA9400IP, in a waterproof cabinet � one ’’Long wire’’ helideck antenna
On the upper deck: � Automatic tuning unit DAA9400IPF, in a waterproof cabinet � 8 m “Whip” antenna.
NOTE: If the installation in a radio room is impossible, the radiobeacon may be installed in a waterproof cabinet, close to the antenna.
�� CHARACTERISTICS OF THE SWITCHING UNIT BRB9300P
The switching unit ensures three functions : � programming of the transmitters by means of LCD’s and
three control keys, � checking of the operation, � display of the parameters.
Programming :RF frequency, modulation type, modulation frequency, code signalDisplay of the parameters :Supply voltage, direct power, reflected power, modulation rate in A2A, RF frequency, transmission type, modulation frequency, code signalSwitching unit criteria :
� Mode NON/A1A : carrier reduction of more than 3 dB, absence of keying
� Mode NON/A2A : carrier reduction of more than 3dB, reduction of the modulation rate of more than 4 dB, absence of keying.
Operation temperature :-20°C to +55°CStorage temperature :-40°C to +70°CPresentation :Drawer unit for 19’’ standard rack, height 2 U
�� TCL9300 IP LINK TELEMONITORING
The switching unit has an interface series type RS232 for telemonitoring. The telemonitoring system is optional and permits to transmit the following information :
� programming parameters, � d.c. supply voltage, � direct power, � reflected power, � transmitter On, � NDB alarm information, � emergency stop information.
Allows to set into service or stop the NDB.
�� CHARACTERISTICS OF THE TRANSMITTER EBT9300P
Power supply voltage :48 VDC (typical)Frequency range :200-535 kHz - synthesized 100 Hz steps (190-700 kHz on request)Frequency stability :< 1 . 10-4Output power :Adjustable up to 100 W (400 W peak) on a 50 ohms load. The power stage is composed of 4 ’’Mosfet’’ transistors mounted in ”H”, ’’D’’ classConsumption for a 100 W carrier :< 3.5 A (carrier non keyed)Modulation type :NON/A1A - NON/A2AModulation frequency NON/A2A :1020 Hz ± 50 Hz, 400 Hz ± 25 HzDistortion :< 5% at 95% modulationHarmonic frequencies :
� < -45 dBc at the transmitter output � < -65 dBc after antenna
Spurious frequencies :< -45 dB compared with the carrierProgramming of the code signal :Up to 5 letters or numbersKeying cyle :
� 20 s in NON/A1A and 15 s in NON/A2A � Dot duration 120 ms. Possibility of indicating stand-by
transmitter and power supply alarm between 2 code signals
Operation temperature :-20°C to +55°CStorage temperature :-40°C to +70°CPresentation :Drawer unit for 19’’ standard rack, height 2 U
EBT9300P
BRB9300P
EBT9300P
TCL9300
AMD9300P
RECTIFIER
�� CHARACTERISTICS OF THE AUTOMATIC TUNING UNIT UAA9400IP
Its ensures the automatic tuning unit of the Daisy antenna despite the possible variations of the tuning capacity caused by the fluctuations of the climatic conditions on the site.
It is housed in a waterproof cabinet equipped with dampers and is installed at the base of the ’’Daisy’’ antenna.
Power supply :48 V (typical)Consumption :< 200 mARF carrier power :100 W NON/A1A - NON/A2AInput impedance :50 ohmsImpedance transformer :5 - 7.5 - 10 - 15 - 20 - 25 ohmsMeasure on 50 ohms :
� direct power � reflected power � antenna intensity
Lightning protection :Spheres discharger located on the cabinet
�� CHARACTERISTICS OF THE ’’DAISY’’ ANTENNA DASP100NM
This antenna is based on the principle of the terminal capacity antenna, which gives a gain of about 6 dB compared with a classical antenna of same height.
It complies with the tightness standards and is mounted on 6 dampers.
Height :1.40 mDiameter at the top :4.40 mMass :98 kgFrequency range :200-700 kHz (self SPD 20100)Admissible power :100 W NON/A1A - NON A2AImpedance :50 ohms
DAISY ANTENNA TOTAL N’KOSSA FPSO
�� CHARACTERISTICS OF THE ’’WHIP’’ ANTENNA AUTOMATIC TUNING DEVICE DAA9400IPF
8 m mast :Insulator fixed on DAA9400IPF cabinetFrequency range :220-700 kHz Admissible power :100 W NON/A1A - NON A2AImpedance :50 ohmsPower supply :48 V (typical)Consumption :< 200 mA
WHIP ANTENNA TOTAL DALIA FPSO
2, avenue de la Butte aux Cailles - BP 302 - 64 603 ANGLET CEDEX - FRANCE Tel.: +33 (0)5 59 58 55 00 - Fax: +33 (0)5 59 58 55 01 - Email: [email protected]
LONG WIRE ANTENNA TOTAL AKPO FPSO
�� CHARACTERISTICS OF THE ’’LONG WIRE’’ ANTENNA AROuNd HELIdECK
The antenna is installed in the plane and around the helideck.The antenna wire goes round the helideck and is isolated from the helideck by fiberglass rods. The automatic tuning unit dAA9400IP is right under.
Fiberglass rods :12, lenght 2 mAntenna wire :Cable inox diameter 3 mmFrequency range :200-700 kHz Admissible power :100 W NON/A1A - NON A2ALength radiating wire recommended :30m < L < 60m
NDB | LOCATOR
Non contractual document
�� CHARACTERISTICS OF THE AUTOMATIC TUNING DEVICE DAA9400IP
It has the shape of a waterproof cabinet, equipped with bumpers. It is installed near the helideck and ensures and keeps the tuning of the ’’long wire’’ antenna, despite the possible variations of the tuning capacity, caused by the climatic conditions on site.
Power supply :48 V (typical)Consumption :< 200 mARF carrier power :100 W NON/A1A - NON/A2AImpedance of connecting antenna :50 ohmsImpedance of adaptable antenna :5 - 7.5 - 10 - 15 - 20 - 25 ohmsMeasure on 50 ohms :
� direct power � reflected power � antenna intensity
Lightning protection :Spheres discharger located on the cabinet