Circuit Simulationusing

Proteus ISIS

Organized by:IEEE HIET Student Branch

&Department of Electronic Engineering

HAMDARD INSTITUTE OF ENGINEERING AND TECHNOLOGY

HAMDARD UNIVERSITY

Instructor:Engr. Abdul Haseeb

Special thanks for organizing this event

• Director HIET & Dean FEST

• Department of Electronic Engineering

• Muhammad Bilal Khan

(Coordinator Electronic Engineering-IEEE HIET SB)

• IEEE HIET SB & its volunteers

• HIET Management Staff

• Programming 1 Lab Staff

• Participants (for joining this event)

About IEEE HIET SB

• One of the largest student branches of Pakistan

• Student Members 96

• Total Members 99

• Best Student Branch of IEEE Karachi Section for the year 2015

• Best Volunteer of IEEE Karachi Section awarded to IEEE HIET SB

volunteer, Mr. Utam Prem for the year 2015

Introduction

• Proteus is the product of Lab-center Electronics Ltd http://www.labcenter.com/

ISIS: Intelligent Schematic Input System(for drawing circuit diagrams)Lab-center Integrated Simulation Architecture (LISA) for simulation of circuit diagram.

ARES: Advanced Routing and Editing Software (for producing PCB layout drawings)

Proteus ISIS IDE Environment

Proteus ISIS Mode

Selection Mode

Component Mode

Junction Dot Mode

Wire Level Mode

Text Script Mode

Buses Mode

Subcircuit Mode

Terminals Mode

Device Pins Mode

Graph Mode

Active Pop-up Mode

Generator Mode

Probe ModeVirtual Instrumentation Mode

2D Graphics

Component ModeTo select Component select Component Mode then click on icon “P” for place component (or simply press key ‘P’)

Place ComponentsSimply type the component name in ‘Keywords’ text box and the select

the category for the desire component

Edit Component Property

Instrument Mode

Terminal Mode

Simulation Section

PLAY

STEP

PAUSE

STOP

Save Schematic Diagram

Fuse Simulation

Flip Flop using Transistor

Power Supply Ripple Analysis

Amplifier

Motivation