Quick TP setting

How the TP configuration on site can be performed quickly and easily in just 4 steps:

1. Log on and choose Site Configuration menua. Set date and time:

Put on a time zone –> GMT+3; click “GET WIN TIME” click “SUBMIT” check if the uploaded time and date are right

b. Set Site Information: fill in the site ID/Name fill in the battery capacity click “SUBMIT” check if the data is submitted properly

2. Configuration Operation/Upload default configuration:

a. Click :BROWSE”b. find the directory where the configuration file is located on your PC and select this filec. click “Send”d. the connection will be interrupted

3. Log on again and go truth an Alarm Configuration menu to check the alarm configuration is right one as below and make sure all 8 Alarms action status are also “Open” (Normal Close).

PS: DIN6 Alarm can be set to NA or Alarm4

All 8 alarms action status should be open as below.

If not, you can change it following the steps as below.

Attention: Please set and submit to save it following one by one item.

4. Go to System Configuration/ Battery summary

a. Put on related capacity as summary value of the strings capacity (1x150Ah=150; 2x150Ah=300; 3x150 = 450…)

b. Fill in the battery installation datec. click “SUBMIT”d. check if the data is submitted properly

The configuration files for TP indoor (TP48200B-N20A6) and TP outdoor (TP48200A-H15A3) cabinets are attached. Important: Don’t mismatch the configuration files – the outdoor one must be uploaded only to outdoor TP and vice versa.

For TP indoor (TP48400B-N20A1) with 8 PSU, please follow the following setting guide to do the alarm configuration and create the saved configuration file for other TP48400B-N20A1 sites .

PS: There are 4 sites with TP indoor (TP48400B-N20A1) in Varna (4005, 4012, 4028, 4125)

Enjoy!