Embed Size (px)
Citation preview
Ca
vit
y a
nd
Co
re C
om
po
nen
ts |
Ru
nner
Shu
t-O
ff In
sert
s –
Appl
icat
ions
(519)968-3367 [email protected] www.componentguys.com
Sabertooth© Mini Carbide Dental Burs
Sabertooth© Mini Carbide Dental Burs (ST-HP)
3/32 shanks -(5 per pkg)
Application: Leverage, extreme pressure and planing motion must be avoided to prevent breakage. Use only with true running handpieces and chucks.Instruments with heavier shaft will afford greater safety. Not recommended for use above 120,000 rpm
High performance carbide
Special process assures a strong bond between carbide and steel
Exact concentricity, durability, resistant to wear.
Ordering info: STHP- _ _ _ _
■
■
■
Dis
cont
inue
d
© RUNNER SHUT-OFFSMachining Information
Dimensions for Machining Pocket for Runner Shut-offs
■ Pockets are typically bored in soft steel and jig ground in hardened steel■ Maintain a close tolerance press fit, as specified. Too loose a fit could allow the insert to move out of position,
Speed Controls
(519)968-3367 [email protected] www.componentguys.com
Shafts, Sheaths, Speed Controls &
Motors
Flexible Shafts & Sheaths forForedom brand motors
Foot heostat for High Speed Motors Manual Control for any motor
Note: Foredom handpiece attachments and other cable driven handpieces are also available
Shafts & Sheaths
Foredom Motors & Foot Controls
Dis
cont
inue
d
