Ensure that you have the 3 matching connector parts.

Screw capConnector body

Bend point

45mm

Quick Assembly Connector (QAC/SC) Assembly ManualFiber Tronix

For Fibertronix part numbers:FT-FIQC5-SC/UPC-MM-3.0, FT-FIQC6-SC/UPC-MM-3.0, FT-FIQC-SC/APC-SM-3.0, FT-FIQC-SC/UPC-SM-3.0

housing

Pass the optical cable through the screw capas shown above. NOTE: This must be done first,or it will not be possible to apply the screw caponce the connector is attached

Strip the jacket from the cable to expose 45mmof the fiber with cladding intact as shown above.

Strip off 35mm of cladding, exposing the barefiber. Insert the fiber into the cleaver and cleave10mm of bare fiber from the end, resulting in acable proportioned as shown above; 10mm ofcladding and 25mm of bare fiber.

1 2

3 4

Insert the fiber into the fiber guide on the connectorbody. When inserted far enough, the fiber will bend,indicating that it is fully inserted.

While maintaining the position of the fiber with theslight bend, slide the yellow locking tab towardthe finished end of the connector to lock the fiberin place.

65

Close the hinged boot cover and slide the screwcap along the fiber to the threaded boot of theconnector and screw the cap on by rotating itclockwise.

7

Position the blue housing as shown above and slide it onto the body of the connector. It willsnap into place. Assembly of the connector isnow complete.

8

DISASSEMBLY AND REASSEMBLY

Pull the blue housing straight off the end of theconnector body. Remove the screw cap byturning it counter-clockwise and slide it down thefiber cable. The threaded part of the body can nowbe opened.

Slide the yellow fiber holder in the oppositedirection from step 6; away from the finishedend of the connector. This will release thefiber from the connector. Pull out the cable thenreassemble.

1 2

For further information regarding Fibertronix products, please visit our website at:

www.�bertronixparts.com

Or call us at: 1-800-688-9282