Upload
others
View
2
Download
0
Embed Size (px)
Citation preview
Shark Navigator Lift-Away Deluxe NV500 RollerBrush Belt Replacement
This guide shows how to replace the roller brush belt in the Shark Navigator Lift-Away DeluxeNV500
Written By: Elena Postupalskaya
Shark Navigator Lift-Away Deluxe NV500… Draft: 2020-05-29Guide ID: 98443 -
This document was generated on 2020-11-19 08:43:49 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 6
INTRODUCTION
Replacing the roller brush belt will require a metal spudger, a screwdriver, and a plastic opening tool.This replacement can help with the rotation of the roller brush.
TOOLS:Metal Spudger (1)Phillips #1 Screwdriver (1)iFixit Opening Tools (1)
Shark Navigator Lift-Away Deluxe NV500… Draft: 2020-05-29Guide ID: 98443 -
This document was generated on 2020-11-19 08:43:49 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 2 of 6
Step 1 — Roller Brush Belt
Lay the vacuum down by hand and locate the roller brush underneath the vacuum cleaner.
Step 2
Insert the metal spudger between the inside side of the wheel and the plastic body.
Push the metal spudger away from you to pop the wheels out.
Repeat the step to remove the other wheel on the other side.
Shark Navigator Lift-Away Deluxe NV500… Draft: 2020-05-29Guide ID: 98443 -
This document was generated on 2020-11-19 08:43:49 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 3 of 6
Step 3
Remove the six 15mm screws usingthe PH1 screwdriver.
Step 4
Move the blue fulcrum connecting the bottom and the main body of the vacuum cleaner back andforth to loosen up crevice between the two halves of the roller brush enclosure.
Shark Navigator Lift-Away Deluxe NV500… Draft: 2020-05-29Guide ID: 98443 -
This document was generated on 2020-11-19 08:43:49 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 4 of 6
Step 5
Insert the plastic opening tool into the crevice between the blue and the dark grey plastic framesenclosing the roller brush.
Apply an outward force throughout and all around the gap in order to separate the two plasticframes.
Step 6
Lift the grey frame off the bottom of the vacuum cleaner with your hands and place it on a flatsurface.
Shark Navigator Lift-Away Deluxe NV500… Draft: 2020-05-29Guide ID: 98443 -
This document was generated on 2020-11-19 08:43:49 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 5 of 6
To reassemble your device, follow these instructions in reverse order.
Step 7
Lift the roller brush slightly upwards using your hand.
Take one side of the black roller brush belt off by pulling it over the end of the roller brush with yourother hand.
Step 8
Remove the roller brush belt withyour hands by sliding it of the end ofthe motor.
Shark Navigator Lift-Away Deluxe NV500… Draft: 2020-05-29Guide ID: 98443 -
This document was generated on 2020-11-19 08:43:49 AM (MST).
© iFixit — CC BY-NC-SA www.iFixit.com Page 6 of 6