The Smart AC Series

Operation Manual

This is an electrical device and should be handled as such.To prevent shock or injury, please keep the iQ2 360W unit awayfrom �re, water and any form of moisture.

This is an electrical device and should be handled as such.To prevent shock or injury, please keep the iQ2 360W unitaway from �re, water and any form of moisture.

DO NOT ATTEMPT to repair or dismantle the iQ2 360W unit. If you are experiencing di�culties operating your unit please contact our Customer Tech and Service Department at1-855-iQ2-7243. Any sign of tampering with the unit may void any Warranty claims.

Use only the approved solar panel and AC charge adapterthat were included with your iQ2 360W. If either of those arebroken and or need to be replaced please contact our technicalsupport division.

Thank you for choosing the iQ2 360W Portable Power Station.The iQ2 360W unit is designed to: provide DC power for lighting,power and charge small accessories: cell phones, iPads, etc via theUSB ports, and provide an electrical power supply for small ACappliances through the built-in inverter. For safe and optimumperformance please use this unit properly. Carefully read andfollow all instructions and guidelines in this manual and give specialattention to ALL WARNING STATEMENTS. Please read the entiremanual before operating the unit.

USB Port

INTERNAL

2000 cycles

Battery

DC OUTPUT

DC Port

12V, 30AH, 360WH

4A

1

WARRANTY and REGISTRATION should be done upon purchasing your iQ2 360W unit. Simply visit our website at: www.iQ2imports.biz

!Due to battery capacity and storage, upon purchasing,the iQ2 360W unit needs to be FULLY CHARGED. If youare charging through the solar panel, simply follow theinstructions and let the unit charge for a FULL 12 - 15 hours,depending on the amount of sunlight. If through the ACadapter, follow the charging instructions and allow the unitto charge overnight. The built-in overload protection willkeep the batteries from overcharging. However, in order toprevent damage, DO NOT leave the iQ2 360W pluggedcontinuously into an AC outlet for more than 24 hours.To guarantee maximum performance and life span, if theunit is being stored and not in continual use, it isrecommended to charge the unit after each use and onceevery 45 days.

LED Light

1

2

1

35W

14.6V, 4A

Accessories Number Designation

IMPORTANT NOTE●

IMPORTANT

NOTE

WARNING

WARNING

WARNING

Technical Data●

Capability, 5V 1.6A, 8W

2 Port number

4

Capability, 12V

Port number

3A, 36W

Solar PanelPower

AC wall charger

12V car adapter

Output Voltage

Port Number

Capability Max

110V

200W

Frequency 60Hz

CHARGING

AC Inverter Outputs

Lithium iron PhosphateBattery Type

Battery Capacity

Life-Span

Optimal ChargingCurrent

Annex●

Solar Panel Power

AC wall charger 1

12V, 3W, and 5m Cables withE27 pin connection and Switch

USB Output iPhone, HTC, Samsung, Nokia, etc.

14.6V, 4A

35 W

Need to car start

360WPORTABLE POWER STATION

Simply Smarter

2

3

5

6

1

4

Front

3. Output USB PortsUSB Ports:2PCS

4. 0utput : DC portsDC Ports:4pcsSize:Φ2.1×6 Output: 12VDC 3A / SET

AC adapter

Car adapter

5. ON/OFFThe switch without control the AC

6. Charger In（Solar In) ,1pcSize:Φ2.5×6Charger In: solar panel

1. Charging and fault lighting

Red-Lighting: charging Red-Lighting: flash

SOLAR CHARGE

OUTPUTUSB DC 5V

OUTPUT DC 12V

OUTPUT DC 12V

OUTPUT DC 12V

OUTPUT DC 12V

OUTPUTUSB DC 5V

Battery level LED indicator

Starting up

Check that the power pack switches are in the “ON” position before charging in.

Recovery voltage

Charging step – By Solar Panel

SOLAR CHARGE

Charging in

Flash - The battery power is low Check that the power pack switches are in the “ON” position,locate the solar panel in direct sun light up to the DC input .

SOLAR CHARGE

Indicates that the system will trigger the low battery Protection,Charging to the recovery voltage , the system can start,Charging to the recovery voltage 12 VDC.

Red-Lighting: charging

Check that the power pack switches are in the “ON” position.

Charge light will turn on while chargingOnce charging completed, four Green lights will stop flashing.

Charging AC Adapter 110V

SOLAR CHARGE

Red-Lighting: charging

Charging in that the four instructions without rules of �ash.

DC OUTPUT

Support USB charging or load to use.Mobile phone chargingUSB*2 parallel output: 5 VDC / 1.6 A General USB output, Support USB charging or load use.

DC jack * 4pcs (5.5*2.1) output:12 VDC,Single-port maximum output 12 VDC / 3A (36W)General use as lighting and etc DC.Includes overload and reverse polarity protection connect using the extension leads of Cigarette LighterAdapter and turn on via the inline switch to each light.

AC Inverter output

Inverter unit runs a loss, when not in use, please turn the main switch o�.

SMART AC inverter output as independent system;Please pay attention to the power AC load, no more than inverter capacity 200W.

The iQ2 360W has a built-in intelligent temperature controlled fan that cools the inverter and will automatically start at 45 C.

Overload and short circuit protection

SOLAR CHARGE

OUTPUTUSB DC 5V

OUTPUT DC 12V

OUTPUT DC 12V

OUTPUT DC 12V

OUTPUT DC 12V

OUTPUTUSB DC 5V

Red �ash - Includes overload and etc protection.

Please turn o� the power switch & Disconnect the load andthen restart.

Includes overload and etc protection.Please turn o� the inverter of power switch & disconnect theload and then restart.

2. Battery Charge Level

Green lighting

SOLAR CHARGE

!

Operation● Operation●Variants●

Push

!

Rear

78

9

7. AC ON / OFF

8. AC output, 1pc

9. AC output indicator light

5VDC 0.6A

5VDC 1A

The iQ2 360W Solar Power Pack is equipped with several built-in safety features. In the event your battery has been fully depleted, and or the unit is not taking a charge (RED charge light indicator will be on while charging) you will need to follow the following charging instructions below in order to reset the Battery Discharge Safety:

* Make sure unit power is "ON" while charging.* Pull charging cord plug, either solar or AC charging, doesn't matter, out of the charging port.* Insert the charge cord plug into the #4 DC Output port. IMPORTANT NOTE: Both the RED charge light indicator and GREEN light charge gauge will light up immediately...REMOVE the charge cord plug from the DC port.* Re-insert charging cord plug into the charging port. The unit will continue charging.* Once the unit is charging the indicator lights will begin to flash.

The AC adapter box will get warm during charging.

SPECIAL NOTE: For maximum battery performance and longevity, it is recommended that you do not fully deplete the battery. Keep the battery charged above 25%.