Standard Parts of Pipe Supports

Embed Size (px)

Citation preview

  • 8/10/2019 Standard Parts of Pipe Supports

    1/5

    Standard parts of Pipe Supports

    ClevisA device which provides for the

    attachment of a threaded rod to a

    bolted or pinned connection.

    Clevises are some of the most

    frequently used linking elements in

    industry. These parts can be found

    everywhere where simple

    movements are required, e.g. linear

    pulling, pushing or even axle offset

    compensation. In addition to

    standard clevises made of steel,there are also clevises made of

    stainless steel.

    TurnbuckleA turnbuckle, stretching screw or

    bottlescrew is a device for adjusting

    the tension or length of ropes,

    cables, tie rods, and other

    tensioning systems. It normally

    consists of two threaded eyelets,

    one screwed into each end of a

    small metal loop, one with a left-

    hand thread and the other with a

    right-hand thread. The tension can

    be adjusted by rotating the loop,

    which causes both eyelets to bescrewed in or out simultaneously,

    without twisting the eyelets or

    attached cables.

  • 8/10/2019 Standard Parts of Pipe Supports

    2/5

    Pipe Clamp

    A pipe attachment for suspension ofhorizontal stationary insulated lines.

    One of the most common clamps in

    the petro and chemical industry.

    Double Bolt Pipe ClampA pipe attachment for suspension of

    horizontal stationary lines.

    Recommended for the suspension

    of pipe requiring up to NPS 4 of

    insulation and where flexibility of

    the clamp may be necessary.

  • 8/10/2019 Standard Parts of Pipe Supports

    3/5

    Extension Pipe or Riser

    ClampA Riser clamp is a device used for

    suspension of vertcal stationary

    lines without the use of hanger rods

    and by mechanical building trades

    to support vertical runs of piping at

    each floor level. The devices are

    placed around the pipe and integral

    fasteners are then tightened to

    clamp them onto the pipe. The

    friction between the pipe and riser

    transfers the weight of the pipe

    through the riser to the buildingstructure. Risers are generally

    located at floor penetrations,

    particularly for continuous floor

    slabs such as concrete.

    Round Bend U-BoltA U-shaped rod with threaded ends

    used as a support or guide.

    U-bolts come in all sizes and

    shapes, but, there are many

    common features. In the

    manufacture of millions of these

    items, there is a common

    nomenclature that appears

    throughout the industry for many of

    the dimensional characteristics.

  • 8/10/2019 Standard Parts of Pipe Supports

    4/5

    Adjustable steel Band

    HangerA pipe attachment for suspension of

    horizontal stationary lines and

    providing a means for vertical

    adjustment. Function: For fire

    sprinkler and other general light

    weight piping purposes.

    Welded attachment

    A structural attachment welded tothe bottom of structural steel

    members and used as a means for

    connecting hanger rods etc..

  • 8/10/2019 Standard Parts of Pipe Supports

    5/5

    Plate Lug

    A structural attachment whichprovides a means of connecting

    rodtype hangers to structural steel

    members via a pin or bolt through

    the hole of the lug.

    Adjustable Pipe SupportThis support type is used for

    support of piping from below

    without welding to the pipe andconsists of a steel saddle, nipple,

    and pipe reducer, and it connects to

    a threaded pipe standard.

    Note: On this page are the most common standard pipe supports specified, but there are many more

    standards available. MSS SP-58 for instance has more then 50 standard Support Types.