1
1% X Blockage Blockage Double bottle-trap Air trapped Double bottle-trap Air trapped Pipe without supportting clamps PROBLEMS Reduced or even zero Dot not use 90 degree bends if at all possible: any sharp bend or series of bends/joints will adversely rate. into the shower tray problems Tube vibration, water leaking from the seal SOLID FLOOR INSTALLATION CAVITY FLOOR INSTALLATION ADDITIONAL RECOMMENDATIONS , etc). . - irregularities in seating in the tray). - Clogged bottle trap INCORRECT INSTALLATION Re-install (Use the correct installations above as a model) check that there is the required minimum 1% slope. Re-install (Use the correct installations above as a model). Get rid of second bottle trap. solution correctly or replace it. Do not use unless acess is possible. Fit pipe supporting clamps (use the correct installations above as a model). CAUSES SOLUTIONS OK 1% OK 1% 50 cm 50 cm 50 cm Clean using a pump. Do not embed solution unless access is possible. TROUBLE SHOOTER SHOWER WASTE

TROUBLE SHOOTER SHOWER WASTE · 2018. 1. 5. · TROUBLE SHOOTER SHOWER WASTE. Title: trouble_shooting_waste_unit Created Date: 7/31/2017 11:22:09 AM

  • Upload
    others

  • View
    3

  • Download
    0

Embed Size (px)

Citation preview

Page 1: TROUBLE SHOOTER SHOWER WASTE · 2018. 1. 5. · TROUBLE SHOOTER SHOWER WASTE. Title: trouble_shooting_waste_unit Created Date: 7/31/2017 11:22:09 AM

1%

50 cm 50 cm 50 cm

X

Blockage

1%

50 cm 50 cm 50 cm

X

Blockage

Blockage

Double bottle-trap

Air trapped

Blockage

Double bottle-trap

Air trapped

Double bottle-trap

Air trapped

Pipe without supportting clamps

Double bottle-trap

Air trapped

Pipe without supportting clamps

Blockage

Double bottle-trap

Air trapped

PROBLEMS

Reduced or even zero

Dot not use 90 degree bends if at all possible: any sharp bend or series of bends/joints will adversely

rate.

into the shower tray

problems

Tube vibration, water leaking from the seal

SOLID FLOORINSTALLATION

CAVITY FLOORINSTALLATION

ADDITIONALRECOMMENDATIONS

, etc)..

- irregularities in seating in the tray).

-

Clogged bottle trap

INCORRECT INSTALLATION

Re-install(Use the correct installations above as a model) check that there is the required minimum 1% slope.

Re-install(Use the correct installations above as a model).Get rid of second bottle trap.

solution correctly or replace it. Do not use

unless acess is possible.

Fit pipe supporting clamps (use the correct installations above as a model).

CAUSES SOLUTIONS

OK

OK

1%

1%

50 cm 50 cm 50 cm

OK

OK

1%

1%

50 cm 50 cm 50 cm

Clean using a pump.

Do not embed

solution unless access is possible.

TROUBLE SHOOTER SHOWER WASTE