1ANSYS, Inc. Proprietary© 2009 ANSYS, Inc. All rights reserved.

February 23, 2009Inventory #002593

Agenda

Workbench – MechanicalIntroduction

2ANSYS, Inc. Proprietary© 2009 ANSYS, Inc. All rights reserved.

February 23, 2009Inventory #002593

Training ManualAgenda (Day 1)

9:00 – 10:00 Lecture – Introduction

10:00 – 11:30 Lecture – Chapter 2: Mechanical Basics

11:30 – 12:00 Workshop 2.1 – ANSYS Mechanical Basics

12:00 – 1:00 Lunch

1:00 – 1:45 Lecture – Chapter 3: General Preprocessing

1:45 – 2:15 Workshop 3.1 – Contact Control

2:15 – 3:15 Lecture – Chapter 3: General Preprocessing (cont.)

3:15 – 3:45 Workshop 3.2 – Meshing Control

3:45 – 5:00 Lecture – Chapter 4: Static Structural Analysis

3ANSYS, Inc. Proprietary© 2009 ANSYS, Inc. All rights reserved.

February 23, 2009Inventory #002593

Training ManualAgenda (Day 2)

9:00 – 9:30 Workshop 4.1 – Linear Structural Analysis

9:30 – 10:00 Lecture – Chapter 4: Static Structural Analysis

10:00 – 10:30 Workshop 4.2 – 2D Structural Analysis

10:30 – 11:00 Lecture – Chapter 5: Vibration Analysis

11:00 – 11:15 Workshop 5.1 – Free Vibration Analysis

11:15 – 11:30 Workshop 5.2 – Pre-Stressed Vibration Analysis

11:30 – 12:00 Lecture – Chapter 6: Thermal Analysis

12:00 – 1:00 Lunch

1:00 – 1:30 Workshop 6.1 – Steady State Thermal Analysis

1:30 – 2:00 Lecture – Chapter 7: Linear Buckling Analysis

2:00 – 2:30 Workshop 7.1 – Linear Buckling Analysis

2:30 – 3:30 Lecture – Chapter 8: Results Post-processing

3:30 – 4:00 Workshop 8.1 – Results Processing

4:00 – 4:30 Lecture – Chapter 9: CAD & Parameters

4:30 – 5:00 Workshop 9.1 – Parameter Management