When and where to use the Jonmaster System

WWG_001 010/2011

Facilitates e�cient daily cleaning Does not replace periodic cleaning tasks(i.e in hard water areas, descaler will still be needed)

Mop facilitates cleaning of small/congested �oor areas

Does not replace mechanical cleaning of large �oor areas

Facilitates light cleaning Does not remove heavy/greasy deposits from surfaces. If area is heavily soiled, use additional chemical and mechanical action

Facilitates cleaning of smooth �ooring

For rough, structured �ooring use the heavy duty Jonmaster mop

Daily / periodic cleaning

Light / heavy cleaning

Small / large area �oor cleaning

Smooth / structured �oor cleaning

How toPrepare TASKI Mops

© 2014 Sealed Air Corporation. All Rights Reserved. 22890HTG_031 en 05/14

3Allow 15 minutes for water to absorb into mops.

5Turn mopsso that velcro is facing upwards.

1 2Take out of the dryer. Keep TASKI mops separate and dry.

Place mops in box on their sides / edges.

Using measuring jug, dampen dry mops with recommended quantity of water.

www.sealedair.com Check SDS for detailed information

Graduation on measuring jug helps identify correct quantity of water for the number of mops being used.

Replace lid and keep closed to maintain moistness in mops.

4

15

50

10

6Attach the mop to the mop head and commence cleaning.

1. Always replace the dirty mops with clean ones after each room.2. Always start from the cleanest area before moving on to a more dirty area.3. Remember - launder cloths and mops separately.4. Never re-use the mops after they have been used in the washroom area. 5. Never use the mops on rough or concrete surfaces.

Golden Rules Washrooms

General

Dry Sweeping Only

How toUse TASKI Mops

© 2014 Sealed Air Corporation. All Rights Reserved. 22890HTG_023 en 05/14

Place the mop head sideways across the mop and lift off the floor. Place in laundry bag. Place any unused mops into the laundry bag at the end of the shift for washing.

6Replace the dirty mop with a clean one by repeating Step 1 above.

1 2Attach the mop to the mop head by applying pressure downwards.

Adjust mop handle to comfortable height (chest level).Loosen handle by turning handle lock quarter of a turn to the left and pulling handle upwards. Lock handle in position by turning handle lock half a turn to the right.

Mop the floor with the leading edge of the mop starting at the furthest point from the exit, following a figure of 8 motion.For tough stains apply extra presure to mop head using the ball of your foot

www.sealedair.com Check SDS for detailed information

5

1. Always replace the dirty mops with clean ones after each room.2. Always start from the cleanest area before moving on to a more dirty area.3. Remember - launder cloths and mops separately.4. Never re-use the mops after they have been used in the washroom area. 5. Never use the mops on rough or concrete surfaces.

Golden Rules Washrooms

General

Dry Sweeping Only

3

When mop is soiled, remove from the mop head by stepping on the 2 edges of the mop. With both hands, pull the handle upwards to release the mop.

4

Use a fresh microfibre cloth dampened with disinfectant solution to clean the mop handle and frame after each isolation room and at the end of the shift.

7