Upload
vokiet
View
220
Download
4
Embed Size (px)
Citation preview
Conventional wastewater treatment lagoons encoun-ter numerous problems that
must be solved constantly. Prime among these problems are the slud-ges that eventually settle to the bot-tom of a pond; under traditional cir-cumstances, these must be removed regularly so that the sludge layer will not accumulate more quickly than it can be biodegraded.
Slow degradation means odorous septic conditions that produce sulfu-ric acid, methane gas and other gases that create low pH conditions, mak-ing pond water more difficult to treat. Such ponds often must hold incoming sewage for six months or longer to achieve acceptable levels of pollution removal.
There is a fundamental reason that these conditions occur: the lack
of an ample oxygen supply to allow bacteria to do its proper job. The beneficial bacteria is aerobic—mean-ing it requires oxygen—and in the presence of sufficient oxygen, the material that settles to the bottom of a pond is eventually biodegraded into carbon dioxide and inert materials. Because a large portion of municipal wastewater consists of biodegradable organic carbon matter, the remaining active bacteria can quickly decom-pose much of the settled sludge.
Plentiful oxygen can be supplied by a few different methods, but the most cost-effective and clean-est method available today is that of windmills. Compressors are turned by wind, and oxygen is then pumped into the pond, aerating the water.
Aeration ApplicationThe benefits of such aeration
were recently realized by the city of Muldrow, Okla. The town has
LAGOONAERATION
Windmill POWER
Windmill wastewater lagoon treatment
systems allow nature to take its healthy course
By Bruce Boyers
40 DECEMBER 2009 • WWW.WWDMAG.COM • WATER & WASTES DIGEST 2010 REFERENCE GUIDE
Windmill
Windmill
WinWinWiWiWWWW
42 DECEMBER 2009 • WWW.WWDMAG.COM • WATER & WASTES DIGEST 2010 REFERENCE GUIDE
LAGOONAERATION
a wastewater pond that is located about 500 yd from a high school and directly adjacent to a baseball field; the lack of oxygen in its water was causing problems.
“When the weather started chang-ing, the water would start getting septic,” said Muldrow City Manager David Taylor. “The smell would get pretty bad.”
Driving down the highway one day, Taylor noticed a windmill on a pond. He observed that the pond water was very clean and inquired about it. His inquiry led to the city being provided two 20-ft windmills on a trial basis by Koenders Wind-mills, Inc. The problem appears to have completely abated.
“The oxygen level is well up in the pond,” Taylor said. “The smell has gone way down.”
A prime indication of the health of the pond is nature itself. “We have lots of turtles out there,” Taylor added. “When you’ve got a lot of tur-tles in a holding pond, that indicates your water is in pretty good shape. We’ve got a lot of ducks and geese landing on it too.”
The health of Muldrow’s wastewa-ter pond has attracted the attention of other municipalities interested in cost-effective and environmentally safe methods of treating wastewa-ter lagoons. The Oklahoma Depart-ment of Environmental Quality also recently paid the city a visit.
The windmills installed were 20-ft double-diaphragm models, as the company has found through research that one such windmill per acre of wastewater lagoon has produced the best results. The
NEW PRODUCT!
The Time Mark Model 42A pump controller is a versatile and advanced liquid level/pump management system. The Model 42A can control up to 3 pumps with a 4-20mA input or 2 pumps with a 4-20mA input and backup fl oats.
For more information on this or other Time Mark products, please visit our website at www.time-mark.com.
DON’T WASTE YOUR MONEY ON OTHER PUMP CONTROLLERS.
WWW.TIME-MARK.COM T M S L : 800-862-2875
Meet the Model 42A Pump ControllerGraphic Display• Expandable• Communications Capable• User Friendly•
write in 171
A windmill contributes to the environment not
only by aerating the pond but by conserving
vital energy as well.
double-diaphragm compressor allows the pumping of double the air of a single-diaphragm model. The wind-mill can provide oxygen with as little as 3- to 5-mph winds.
Using Nature to Restore Nature
Adequate aeration is also impor-tant for keeping lagoon water mixed and in suspension. Insufficient mix-ing causes the creation of thick solids that fall to the bottom of the lagoon before proper treatment has occurred. Septic conditions then occur that pull available oxygen from the upper layers of the pond and reduce the overall effectiveness of treatment.
When water is in an ideal mixed condition, incoming pollutants and wastewater are more evenly distrib-uted, resulting in uniform and effi-cient treatment. The action also causes settled solids to be resus-pended and brought back into con-tact with the microbial population floating throughout the pond.
Another method of providing oxygen to wastewater ponds is pow-ered aerators operating with motors. While these may be effective at pond aeration, they are expensive in terms of power consumption. A windmill obtains its power directly from the wind and consumes no electrical power; hence, it contributes to the environment not only by aerating the pond but by conserving vital energy as well.
These windmills are being suc-cessfully used in farm ponds, golf courses, stocked fishing ponds, resi-dential ponds and lakes. They restore water quality and reduce algae and mosquito problems.
They are a case of using nature to restore nature. Proper treatment of wastewater lagoon systems with windmills is another step in safely reclaiming our environment. WWD
Bruce Boyers is a freelance writer. For
more information, contact Koenders
Windmills at 888.777.4933 or by e-mail at
For more information, write in 1105 on
this issue’s Reader Service Card.
LAGOONAERATION
WEBresourcesRelated search terms from
www.waterinfolink.com:
aeration lagoons, windmills
For more information
related to this article, visit
www.wwdmag.com/lm.cfm/wd120905
·Lower installation andrestoration costs
·Installs under pressure (IUP)and can be repaired underpressure (RUP)
·Water Conservation·Immediate Isolation Zonesfor Security
·Trench and Employee Safety
·No shut down or backflowissues
800-662-8326
Valve Repair Services • Field Machining Services • Emissions Control Services • Leak Repair ServicesHot Tap Services • Technical Bolting • NDT and Inspections • Pipe Repair Services • Mobile Heat Treating
Tap Into These Benefits.
Tap, Tap, Tap.
www.teamindustrialservices.com/ads/wwwdigest
Contact Team foryour next live valve cut-in.
write in 168
2010 REFERENCE GUIDE WATER & WASTES DIGEST • WWW.WWDMAG.COM • DECEMBER 2009 43