RD20 RD40 SD10
The RD20 is perfect for exposed locations such as perimeter doors and open carports. The RD20 is well suited for single roll up garage doors.
Minimum side room requirement: 40mm
Recommended side room requirement: 80mm
Peak lifting force: 550N
Typical travel speed: 100mm/sec
Receiver storage capacity: 8 x 4 button transmitter
Code combinations: 4.29+ billion random codes
The RD40 is an international standard in roll up garage door automation. This more powerful unit is well suited for larger double roll up doors.
The SD10 is a compact, yet powerful, opener perfectly suited for use on single or double panel garage doors.
Minimum headroom requirement: 57mm
Peak lifting force: 650N
Typical travel speed: 140mm/sec
Receiver storage capacity: 8 x 4 button transmitter
Code combinations: 4.29+ billion random codes
Door Type: Single/Double Car Roll UpMax Door Height: 2.7mMax Door Area: 13.5m²
Door Type: Double Car Roll UpMax Door Height: 2.7mMax Door Area: 15m²
Door Type: Double Car PanelMax Door Height: 2.4mMax Door Area: 13.5m²
Warranty: 2 year or 5000 cycle warranty on drive unit. 12 months on other components and accessories. Please read warranty terms in the enclosed manual for full details.
Warranty: 2 year or 5000 cycle warranty on drive unit. 12 months on other components and accessories. Please read warranty terms in the enclosed manual for full details.
Warranty: 2 year or 5000 cycle warranty on drive unit. 12 months on other components and accessories. Please read warranty terms in the enclosed manual for full details.
Weather Resistant: For installations where the opener is exposed to the elements, the unit is sealed to prevent damage from water (IP24)
Soft stop/start: Ramping speed up and down at the start and end of each cycle of the door reduces stress on the opener for longer life and quieter operation and prevents a “bang” when the door stops moving.
Soft stop/start: Ramping speed up and down at the start and end of each cycle of the door reduces stress on the opener for longer life and quieter operation and prevents a “bang” when the door stops moving.
Minimum side room requirement: 40mm
Recommended side room requirement: 80mm
Peak lifting force: 600N
Typical travel speed: 120mm/sec
Receiver storage capacity: 14 x 4 button transmitter
Code combinations: 4.29+ billion random codes
soft stop/start soft stop/startweather resistant
www.diyopener.com.au
DIY GARAGE DOOR OPENERS
DIY GARAGE DOOR OPENERS
ROLLER DOOR INSTALLATION
SECTIONAL DOOR INSTALLATION
1. Prep the door
2. Attach the weight bar
3. Raise one end of the door
4. Slide the opener on
5. Set limits
6. Code transmitters
TOOLS REQUIRED FOR INSTALLATION: • Ladder • Adjustable wrench • Socket set • Drill • Screwdrivers • Marker pen• Door stand (adjustable step ladder can be used)• Towel or large piece of foam
IMPORTANT SAFETY WARNING: While garage doors look safe, they can be VERY dangerous if not handled properly. They contain springs that are under extreme tension and must be handled VERY carefully to avoid injury. Please take a moment to read the safety information in the installation manual before commencing the installation.
Please refer to the enclosed installation manual for details. Please refer to the enclosed installation manual for details.
1. Prep the door
2. Assemble the C-Rail
3. Attach the powerhead to rail
4. Mount the opener
5. Set limits
6. Code transmitters
www.diyopener.com.au