3D PRINTED FACE SHIELD PREPARE - PAGE 1 ......3D PRINTED FACE SHIELD WARNING: FOR USE AT OWN RISK....

3D PRINTED FACE SHIELDWARNING: FOR USE AT OWN RISK. This mask has NOT been approved by an official medical organization. Not for continued use after COVID-19 pandemic emergency.

Attach elastic band

Get started

Prepare plastic sheets

Test elastic band

• TUG FIRMLY on both knots to make sure the band is secure

• TRIM off excess elastic

• Ensure all materials are sanitized after use

Replace band as needed

Attach elastic band toHead Frame

• Pull elastic loop around CLEATS on both ends of head frame

• ENSURE elastic is not twisted between the cleats

5

Punch holes

• FEED the 11 inch side into hole punch

• PUSH down on top of hole punch firmly

• Check to ensure edges are clean and straight

7

Gather supplies

3D Printed Head Frame

Elastic Band 13” - 14“ in length

2x 8.5” x 11” Rigid Clear Plastic Sheetsex. Binder cover, report cover

1

6

3 Hole Punch(standard)

Scissors

Ball Point Pen

Ruler

!

CLEAT

!

Prepare elastic band

Measure elastic band

• CUT elastic13 - 14 inches in length

2 Tie Overhand Loops on each end

• CREATE LOOP A at the end of elastic

• FEED LOOP B through back of LOOP A

• HOLD end of LOOP A and PULL ON LOOP B to tighten

3 Check length

• MEASURE 9”-10” from each loop

4

PREPARE - PAGE 1

13”-14”

LOOP B

LOOP A

9”-10”

Create Top Shield

• MEASURE, MARK & CUT three 3” strips

For more precision, use a craft knife or a cutting board.

Punch holes in remaining strips for two more face shields!

83 INCHES

Attach top shield

Link to the STL for the 3D Printed Face Shield here:www.covidsupplyconnection.com

Attach Small Plastic Sheet

• Line up holes up with pegs and snap into placeExpect to feel some tension at the last peg.

11

Attach bottom shield

Attach Large Plastic Sheet

• Line up holes up with pegs and “snap” into placeExpect to feel some tension at the last peg.

10 SNAP!

SNAP!

3D PRINTED FACE SHIELDWARNING: FOR USE AT OWN RISK. This mask has NOT been approved by an official medical organization. Not for continued use after COVID-19 pandemic emergency.

Get startedGather parts

3D Printed Head Frame with Elastic Band attached

3” x 11” plastic sheet

8.5” x 11” plastic sheet

9

!ASSEMBLY - PAGE 2

WARNING: Take precautions when delivering. Wear protective gear like masks and gloves.

DO NOT deliver when sick.

!