Manufacturing a mobile phone holder. Manufacture of mobile phone holder – plastic The selected...

Manufacturing a mobile phone holder

Manufacture of mobile phone holder – plastic

The selected design is cut out using a laser cutter.

A rest is needed at the base of the phone – how can this be achieved?

Line bending the plastic

Manufacture of mobile phone holder – plastic

Line bending involves heating a

thermoplastic sheet of material over a

strip heater until it becomes softened and then bending it into the required shape. It can be

shaped manually or with a jig to bend the plastic to a specific angle. As the plastic cools it

hardens.

Thermoplastic sheet

Strip heater

What is line bending?

Manufacture of mobile phone holder – plastic

The first line is heated over the strip heater

An then completed at a right angle to the rest of the plastic.

Manufacture of mobile phone holder – plastic

The second bend is then heated and

made at the base of the fins, and

again completed at right angles

Manufacture of mobile phone holder – plastic

The side bends are heated and

folded back one by one

A block of wood can be used to

support the side bends – see below.

Manufacture of mobile phone holder – plastic

Completed mobile phone holder

Click once to revolve

Manufacture of mobile phone holder – plastic

Other mobile phone holder designs

Watch the Flash animation it will help you with your manufacture

Manufacture of mobile phone holder – plastic

Recap – what is happening here

Recap – what is happening here?

Click once and wait a little each time