Contact Address：5th Floor,LiDong Technology Building,High-tech Zone, Guilin,China

Email：info@xyfx-model.comwww.xyfx-model.com.cn

30cc G eebee- R3 ARFASSEMBLY MANUAL

桂 林 鑫 鹰 飞 翔 模 型 有 限 公 司Guilin XinYing FeiXiang Aircraft Model Co.,Ltd

KIT CONTENTS

P01

Stick the hinges to the rudder firmly with AB glue

P02

Fix the control horn to rudder

P03

Drill a 6mm diameter hole on the bottom of rudder, fix the steel wire to the bottom of rudder with

AB glue

P04

Put some AB glue on the hinges which link with rudder, then stick to the fuselage

P05

Fix the tail landing to fuselage

P06

Assemble control horn, rudder cable, ball link and connecting rod to rudder

P07

Fix rudder servo, rudder cable, ball link and connecting rod as picture

P08

Stick the hinges to the elevator firmly with AB glue

P09

Fix the horn to elevator with self-tapping screws

P10

Put some AB glue on the hinges which link with elevator, then stick to the horizontal tail

P11

Cut the hole on fuselage for elevator servo

P12

Fix the elevator servo as picture

P13

Assembly horizontal tail to fuselage, then measure the same angle for both sides

P14

Fix horizontal screws, rubber loop and washer

P15

Check the horizontal tail and fuselage at correct angle, then fix them with screws

P16

Stick hinges to aileron firmly with AB glue

P17

Put some AB glue to hinges which link with aileron , then stick to the wing

P18

Fix control horn, push rod and servo to the aileron

P19

Cut the film on the wing for landing gear

P20

Check the right or left side landing gear, then assembly it

P21

Put some AB glue into landing gear trail on the wing, then fix the landing steel wire firmly

P22

Fix the landing gear plates as picture

P23

Fix the wheel and wheel adapter as picture

P24

Put the wheel active cover on the wheel pant, then drill hole to fix it on the wheel pant

P25

Drill hole on the wheel pant, then fix it to the wing

P26

Cut the film on the fuselage for wing

P27

Push the wing into fuselage as picture

P28

Fix the two wings to fuselage with two screws one each side

P29

Align mounting template with fire wall and tape in place

P30

Drill engine mounting holes according to the signals on fire wall

P31

Fix the engine to fire wall as picture

P32

Gather the fuel tank parts as picture

P33

Fix the fuel tank as picture

P34

How to drill a hole on the cowling: tape one piece paper on the fuselage and mark the hole

position, then put the cowling on fuselage and align it with the hole, then drill the hole on cowling

P35

Fix the cowling on fuselage with screws

P36

Fix the spinner and propeller onto the engine

P37

Fix the canopy on fuselage with screws as picture

P39

The installation is completed!

ENJOY YOUR FLY!!!

CG as above picture

P38