W h e r e S m a r t S o l u t i o n s Ta k e F l i g h t ®

T E C H N I C A L D ATAInstruction Sheet for Semco® Click-Patch Kit™

Epoxy Repair Kit for All Types of Leaks

Complete package with epoxy kit, mixing plate, solvent cleaning pad and surface abrader, and Click-Patch™.

Use surface abrader to clean surface to bare metal.

Use surface abrader to lightly abrade surface of patch.

Use solvent cleaning pad to clean surface to be repaired.

Use solvent cleaning pad to clean patch.

Puncture one epoxy tube at neck end and dispense all material onto mixing pad.

Puncture other epoxy tube at neck end and dispense all material onto mixing pad.

Mix thoroughly until mixture becomes one color.

Apply a small amount of material to the center of the patch.

PRC-DeSoto International, Inc.12780 San Fernando RoadSylmar, CA 91342Telephone (818) 362-6711Toll Free (800) AEROMIXwww.semcopackaging.com

Issue Date: 12/10Supersedes: 05/00Lit: 0643

Semco is a trademarks of PRC-DeSoto International Inc., registered with the U.S. Patent Office.Click-Patch is a trademark of Physical Systems. Inc.

All recommendations, statements, and technical data contained herein are based on tests we believe to be reliable and correct, but accuracy and completeness of said tests are not guaranteed and are not to be construed as a warranty, either expressed or implied. User shall rely on his own information and tests to determine suitability of the product for the intended use and assumes all risks and liability resulting from his use of the product. Seller’s and manufacturer’s sole responsibility shall be to replace that portion of the product of this manufacturer which proves to be defective. Neither seller nor manufacturer shall be liable to the buyer or any third person for any injury, loss, or damage directly or indirectly resulting from use of, or inability to use, the product. Recommendations or statements other than those contained in a written agreement signed by an officer of the manufacturer shall not be binding upon the manufacturer or seller.

Printed in the U.S.A

Instruction Sheet for Semco® Click-Patch Kit™

Epoxy Repair Kit for All Types of Leaks

Allow material to settle out. Remove protective green tape. Center patch over leak and press firmly on outer edges of the Click-Patch™ cover.

Press firmly on center of Click-Patch™ cover to activate click mechanism, forcing patch and material to the repair area.

When mixing stick cannot be removed from material, the Click-Patch™ cover can be removed.

Remove cover by grasping the edge of the cover and peeling up. Puncture other epoxy tube at neck end and dispense all material onto mixing pad. Mix thoroughly

The repair is now complete. Excess material can be trimmed before total cure occurs and then surface painted, if required.