Upload
marcus
View
215
Download
0
Embed Size (px)
Citation preview
8/14/2019 DJ-C5 Transeiver
http://slidepdf.com/reader/full/dj-c5-transeiver 5/11
1. Turn the power on.
2. Adjust the volume, if needed.
3. Adjust the squelch level, if needed.
4. Select a frequency.
5. When you receive a signal ...
To transmit
Slide the PWR switch to "ON " (right).
Press -p" to disengage the squelch, and press "g' , thenpress 3 & to select a volume level from 1 to 8. The higherthe number the louder the volume. Recommended level for thesperker is 6-8.
Fortheoptionalearphone. avolumelevel ecommendedis2-4,
and 6-8 is too loud that can cause hearing hazard.Press to engage the squelch.
Press z?' twice, then press / & to select a squelch level
frwn 0 to 5. The larger the number the tighter the squelch.After a few seconds the radio comes back to frequency display.
Selecl a band with 8 . Press "gi I 6 to increase or decreasethe frequency in one tuning step. To change the frequency in1 MHz step, press @ to display 0 then press I 6
,
BUSY appears on the display and you can hear the otherperson's voice from the speaker. If it is hard to hear, press
@ (BUSY appears) to disengage the squelch . To re -engage
the squelch , press or &Holdl a m will turn red.
Mo*,TW
down and speak into the microphone. The transmit
, There are three operation modes: VFO, Memory, and CALL.~ The figure on the right shows the key operation forchanging these modes.
The radio will start up in the VFO mode by factory-default-
VFO Mode
1You can manually select the frequency. While in the VFO
mode, the 'M " or "c" is not on the display.
To change the frequency:select a band with 8 . Press 8 I 6 to increase or decrease the frequency in one tuning step
- 8 41 Memory Mode]
To scan :
Hold down 3 & for a while to start scanning. Scanning will pause if a frequency receiving a signalis found. After five seconds, scanning will automatically restart. The decimal *." blinks while scanning.Press P l l to slop scannina.
Memory ModeThe rnernorv mode provides 50 mernorv channels (1 to 5 0 ) . allon
-inq you to easily access pre.
programmed frequencies. To go to the memory mode, press & ,so that "M' appears in the extreme
left. The number below the "M' is the channel number. If the channel is blank (unprogrammed), "----- *isdisplayed instead of a memorized frequency.To call up only frequency -proqrammed memory channels , be in the Memory Mode with the 'M'displayed. and pressin the Memory Mode with the "M" displayed, and press @ to display 0 then press
I 6 . To call up both blank and frequencyprogrammed memory channels, be
/ .
9(continued to next page)